Product Description:

The 00.F5.060-FA00 is an axis drive in KEB's F5 Combivert series. It is built for closed-loop speed and torque control in automated machinery. The unit converts PLC commands into regulated motor output and exchanges real-time data through an integrated EtherCAT interface.

Service access is provided through port X6B, where technicians can review parameters and event logs. For network communication, the drive uses X6C In and X6D Out on shielded RJ45 connectors that follow IEEE 802.3 100Base-T. The physical link runs at 100 Mbit/s, which supports daisy-chained drive layouts without requiring a separate switch. No encoder feedback card is installed, so position data must come from external sensors or an optional plug-in board.

The communications firmware manages 4 sync-manager channels to coordinate deterministic data exchange. A minimum sync cycle of 1 ms helps the controller maintain predictable motion timing during operation. Extended PD mode supports up to 16 byte per direction for larger command sets, while the mailbox carries as much as 50 byte of asynchronous CANopen-over-EtherCAT traffic. Startup coordination uses predefined control and configuration registers so the drive joins the network in a known state.

Wake Industrial stocks this drive for immediate order fulfillment. Same-day shipping is available when timing is critical, and written quotations remain valid for 30 days. Customers can use the chat tool available on the website for general questions about type codes or fault codes. Inventory support helps reduce downtime during replacements, and prompt order processing is available for urgent maintenance schedules when production cannot wait.