00.F5.060-9002 KEB
Wake Industrial LLC is not an authorized distributor of this product.
The KEB 00.F5.060-9002 is a cable for the F5 Combivert Axis Drives series. It uses a CAT5 patch cable with an RJ45 socket connector and features both shielding and designated transmit and receive pairs. The interface type is HSP5/485, and reference pins are provided for grounding.
Internal Product Review
The 00.F5.060-9002 is a KEB CAT5 patch cable for Combivert F5 axis drive communication, featuring an RJ45 socket and HSP5/485 interface support. Shielding and dedicated transmit/receive pair assignments give the cable clean signal performance, making 00.F5.060-9002 a strong choice for stable drive-network connectivity.
To contact sales for pricing and lead time:
Payment Methods
Shipping Methods
Our Credentials
Product Description:
The 00.F5.060-9002 communication lead is supplied by KEB for integration within the F5 Combivert Axis Drives series. Classified as an accessory rather than a power conductor, the cable links drive-mounted control boards to external PLC or supervisory equipment, allowing parameter downloads and real-time diagnostics across factory networks. Its role in automation is to provide a dedicated data path that matches the electrical conventions used inside Combivert controllers while preserving signal integrity over short panel runs.
Electrical performance is based on its rating as a CAT5 patch cable, which supports balanced twisted-pair signaling up to 100 MHz so the drive can exchange status words without timing errors. The molded end carries an RJ45 socket, giving a keyed eight-contact layout that seats directly onto the control card header. Data framing conforms to the HSP5/485 interface, a half-duplex differential layer compatible with RS-485 transceivers embedded in the F5 inverter CPU. Outbound telegrams leave the drive on the dedicated transmit conductors numbered 4=TXD+, 5=TXD-, and inbound telegrams return on the receive conductors labeled 1=RXD+, 2=RXD-. By separating these pairs, crosstalk is reduced and the controller maintains stable edge transitions even in cabinets with variable-frequency noise sources.
Ground reference is established through the drain lines at 3=GND, 6=GND, permitting the differential line drivers to remain centered around zero volts during bursts of common-mode interference. A separate handshake circuit is provided on pins 7=EnRxD+, 8=EnRxD-; the master enables the receiver through this pair so that idle bus segments stay in a high-impedance state. Continuous metallic shielding is bonded to the drive chassis at the connector shell, preventing radiated emissions from escaping the enclosure. The accessory uses the Combivert F5 designation, which indicates compatibility with matching axis drive connections.
