00.F5.060-5000 KEB
Wake Industrial LLC is not an authorized distributor of this product.
The KEB 00.F5.060-5000 is part of the F5 Combivert Axis Drives series and uses a CANopen bus protocol with automatic bit rate detection. It supports CAN data rates up to 1000 kbit/s with ISO 11898 high speed physical layer and VDE0160 safe isolation. The drive offers a maximum CAN payload of 8 bytes and features both D-SUB-9 male and female connectors.
Internal Product Review
The 00.F5.060-5000 is a KEB F5 Combivert axis drive configured for CANopen communication on an ISO 11898 high-speed physical layer. Automatic bit rate detection and VDE0160 safe isolation support dependable integration in machine control systems. The unit stands out as a network-ready drive solution with CAN data rates up to 1000 kbit/s.
To contact sales for pricing and lead time:
Payment Methods
Shipping Methods
Our Credentials
Product Description:
The 00.F5.060-5000 is an axis drive unit manufactured by KEB for the F5 Combivert Axis Drives series. In a typical installation, the module converts DC-link energy into controlled three-phase output that manages motor speed and torque on packaging lines, material-handling gantries, or process equipment. Because the drive integrates a fieldbus node, it can exchange setpoints, actual values, and fault codes directly with the machine PLC instead of relying on separate hardwired signaling for every command. That arrangement suits distributed machine layouts where local control data and inverter output are handled in the same module. It also supports decentralized motion control and reduces panel wiring in industrial automation cells.
The communication interface follows the CANopen profile on an ISO 11898 high-speed physical layer. Supported network bit rates span 10/20/25/50/100/125/250/500/800/1000 kbit/s, and the controller selects the correct rate through automatic detection at power-up. A fixed bus termination of 124 ohms is integrated, so no external resistor is needed at the drive end of the trunk. Six assigned identifiers structure device access, while a default node address of 1 supports initial setup. Up to 2,032 CAN 2.0A identifiers are accepted, and the product is classified as a minimum-capability device to match CiA device-class guidelines. No encoder feedback card is installed at the factory, so closed-loop operation requires the designated option board.
Message handling accommodates a maximum payload of 8 bytes per frame. Receive identifiers are processed at 29-bit width, while transmit identifiers are restricted to 11-bit. The bus uses one male and one female D-Sub-9 connector, with CAN H on pin 7 and CAN L on pin 2 for daisy-chain wiring. The connector pair allows the network cable to enter and leave at the same unit without additional terminal hardware. Internal galvanic separation meets VDE0160 safe isolation, protecting low-voltage control electronics from high-energy inverter sections.
