FC-301P75KT4134L2697 Danfoss
Wake Industrial LLC is not an authorized distributor of this product.
The Danfoss FC-301P75KT4134L2697 is part of the VLT FC 301 Automation Drives series and is rated for 100 horsepower and 75 kilowatts. It operates on three phase power with a mains voltage range of 380 to 480 VAC and features four digital inputs with a maximum voltage of 28 V DC. The drive supports a maximum output frequency of 590 Hz and provides an overload capacity of 150% for 1 minute out of every 10 minutes.
Internal Product Review
The FC-301P75KT4134L2697 is a Danfoss VLT FC 301 automation drive well suited for demanding motor control, with a 75 kW rating and 380 - 480 VAC three-phase input. Strong overload capacity at 150% for 1 min/10 min and output frequency up to 590 Hz make this unit a highly capable choice for high-performance drive applications.
To contact sales for pricing and lead time:
Payment Methods
Shipping Methods
Our Credentials
Product Description:
The FC-301P75KT4134L2697 is an automation drive produced by Danfoss for the VLT FC 301 Automation Drives series. It functions as an adjustable-speed interface between a three-phase power bus and an asynchronous motor, allowing industrial controllers to match motor speed to process demand. In automated conveyors, mixers, and pump stations, the unit modulates output frequency and voltage to reduce energy use while maintaining stable torque. Its control architecture supports variable-speed operation across a range of industrial processes.
The drive accepts a three-phase input of 380–480 VAC. Its continuous output is rated at 75 kW, which corresponds to 100 hp. For short overloads, it can supply 150% output for one minute during each 10-minute interval. An overvoltage alarm is triggered at 820 V DC to protect the DC-link capacitors. Application dynamics are supported by a maximum output frequency of 590 Hz, while flux-vector operation has a ceiling of 300 Hz. The drive has four discrete inputs for start, stop, and preset commands, and each Safe Torque Off channel draws 50 mA RMS. Its digital output stage can source up to 40 mA for status signaling. Control conductors can range from 0.25 mm² to 1.5 mm², providing flexibility when routing wiring through cabinet ductwork. The unit may be energized once per minute to limit wear on the inrush charging resistors.
Motor leads may extend up to 50 m with shielded cable or 75 m with unshielded cable without exceeding the stated EMC limits. Pulse signals can leave the terminal block at rates up to 110 kHz, supporting high-speed communication with compatible control equipment. The drive logic accepts input levels up to 28 V DC, allowing direct connection of suitable PNP sensors. An internal timer monitors the permitted power-up interval and helps prevent repeated energization before the inrush network is ready. Shield selection and cable length should account for the surrounding electrical environment and the required electromagnetic compatibility. The available conductor range also allows control terminals to accommodate common industrial wire sizes without oversized cable entries.
