FC-301P30KT4134L2693 Danfoss
Wake Industrial LLC is not an authorized distributor of this product.
The Danfoss FC-301P30KT4134L2693 is part of the VLT FC 301 Automation Drives series and has a power rating of 30 kW with a rated efficiency of 0.98. It supports a mains voltage of 380 to 480 VAC, operates on three phase power, and provides a maximum output frequency of 590 Hz. The drive features 2 digital outputs at 40 mA each, a 12-bit analog output resolution, and supports up to 40 HP.
Internal Product Review
The FC-301P30KT4134L2693 is a Danfoss VLT FC 301 automation drive designed for dependable motor control on 380 to 480 VAC three-phase power. The 30 kW power rating and 40 HP capacity give this unit strong application range and stable throughput in demanding automation service. Rated efficiency of 0.98 is a standout advantage for energy-conscious installations.
To contact sales for pricing and lead time:
Payment Methods
Shipping Methods
Our Credentials
Product Description:
The FC-301P30KT4134L2693 is an AC variable frequency drive manufactured by Danfoss for the VLT FC 301 Automation Drives series. The unit converts fixed three-phase mains power into a regulated output that allows process controllers to adjust motor speed and torque in conveyors, pumps, and material-handling equipment. Its configurable control architecture supports a variety of general industrial automation tasks.
The drive delivers a continuous mechanical output of 30 kW, so it is sized for midrange induction motors used on heavy airflow or material-feed lines. It accepts a three-phase input of 380–480 VAC, allowing direct connection to standard plant distribution networks without transformers. Under nominal load, its efficiency reaches 0.98, limiting heat losses inside the cabinet. The inverter can modulate motor speed up to 590 Hz, providing a broad adjustment range for closed-loop controllers. A flux-mode ceiling of 300 Hz helps preserve torque at low shaft speeds. Two digital or pulse outputs source 40 mA each, and a relay contact supplies a separate fault channel. The 12-bit analog output transmits process values, while the 10 V/15 mA and 24 V/200 mA supply taps power external sensors.
The power section issues a high-voltage warning when the DC link rises to 810 V DC and activates an overvoltage alarm at 820 V DC, allowing a controlled shutdown before component limits are exceeded. Internal IGBTs support a carrier frequency of 32 kHz, which can be selected when lower acoustic noise or reduced torque ripple is required. Motor leads can extend to 50 m with shielded cable or 75 m with unshielded cable while meeting the output waveform requirements of the VLT FC 301 platform. These cable-length limits allow the drive cabinet to be positioned away from the motor without requiring additional dV/dt filters or output reactors under the stated installation conditions.
