Product Description:

The FC-301P2K2T4E66H2BGXXSXSXXXXAXBXCXXXXDX is an AC variable frequency drive manufactured by Danfoss for the VLT FC 301 Automation Drives series. It converts fixed-frequency mains power into a variable-frequency, variable-voltage output for controlling the speed and torque of compatible AC motors. This control allows pumps, fans, conveyors, and material-handling equipment to operate at speeds that match process demand. Reducing unnecessary motor speed can lower energy consumption and limit mechanical wear in industrial automation systems.

The inverter accepts 380–480 VAC from a three-phase power supply. Its continuous motor output is rated at 2.2 kW, which corresponds to 3.0 HP. The variable output enables smooth acceleration and deceleration while supporting regulated motor operation across the required speed range. An integrated brake chopper directs regenerative energy toward a suitable braking resistor during rapid deceleration or operation with an overhauling load. No additional EMC filter is installed, so radio-frequency interference mitigation relies on the drive’s base filtering arrangement and proper installation practices.

The enclosure has an IP66 / NEMA 4X rating, allowing the drive to be mounted on suitable machinery without a separate protective cabinet. Its housing resists dust, water jets, and common outdoor exposure when all entries and covers are installed correctly. Configuration and local operation are handled through a Graphical Local Control Panel supplied with the standard language pack. The display provides access to operating values, parameter menus, status information, and fault messages directly at the unit. Power and control conductors pass through imperial smooth cable entries, which support inch-based conduit hardware without metric adapters. The printed circuit board is uncoated, so the mounting location should remain free of corrosive vapors and contaminants that could damage exposed electronic components.