FC-301P1K5T4134L2643 Danfoss
Wake Industrial LLC is not an authorized distributor of this product.
The Danfoss FC-301P1K5T4134L2643 is part of the VLT FC 301 Automation Drives series and has a power rating of 1.5 kW with a rated efficiency of 0.97. It operates on three phase power at a mains voltage of 380 to 480 VAC and supports a maximum output frequency of 590 Hz. The drive is equipped with one analog output at 12 bit resolution and two digital outputs.
Internal Product Review
The FC-301P1K5T4134L2643 is a Danfoss VLT FC 301 automation drive designed for 380 - 480 VAC service on three-phase power. A 1.5 kW power rating and 0.97 rated efficiency support efficient, stable performance in demanding motor control applications. Maximum output frequency to 590 Hz stands out as a key advantage for responsive automation duty.
To contact sales for pricing and lead time:
Payment Methods
Shipping Methods
Our Credentials
Product Description:
The FC-301P1K5T4134L2643 is an AC variable frequency drive produced by Danfoss as part of the VLT FC 301 Automation Drives series. This three-phase inverter receives fixed-frequency mains power and delivers a modulated output to control induction motor speed in conveyors, pumps, and material-handling cells. By adjusting output frequency according to process demand, the unit helps reduce energy consumption and mechanical wear in industrial automation. Its variable-speed operation also supports controlled acceleration and deceleration, reducing abrupt changes in motor torque during routine machine cycles.
On the input side, the drive accepts 380–480 VAC three-phase power and draws a maximum of 3.7 A when supplied at 380–440 V. It provides a rated motor output of 1.5 kW, equivalent to 2.0 HP, while apparent power at 400 V reaches 2.8 kVA. Output current can reach 4.1 A within the same voltage range. Continuous power losses are limited to 62 W, which helps reduce the ventilation required inside the control cabinet. Electrical conversion efficiency is 0.97, so most incoming energy is delivered to the motor rather than dissipated as heat. These electrical values support the selection of suitable fuses, contactors, conductors, and cabinet cooling equipment for the installation.
Control interfaces include one analog channel with 12-bit resolution and two digital outputs, allowing a PLC to provide speed or torque commands and receive operating signals. The ±10 V reference terminal can source up to 15 mA, while the integrated 24 V logic rail supports connected sensors drawing up to 200 mA. Carrier settings permit a maximum flux frequency of 300 Hz and an output frequency ceiling of 590 Hz, providing a broad operating range for compatible high-speed motors and spindles. Motor leads may extend up to 50 m when shielded or 75 m when unshielded without compromising drive performance. These cable-length allowances provide flexibility when the motor and drive must be installed in separate areas of a machine while maintaining applicable electrical noise limits.
