FC-301P1K5T2134G0681 Danfoss
Wake Industrial LLC is not an authorized distributor of this product.
The Danfoss FC-301P1K5T2134G0681 is part of the VLT FC 301 Automation Drives series and operates on 200 to 240 VAC three phase power with a power rating of 1.5 kW. It supports a continuous output current of 7.5 A and delivers up to 2.0 horsepower with an efficiency of 0.96. The drive features 2 digital outputs, a 12-bit analog output resolution, and allows for shielded motor cable lengths up to 50 meters.
Internal Product Review
The FC-301P1K5T2134G0681 is a Danfoss VLT FC 301 automation drive with a 1.5 kW power rating and three-phase power input. Operation feels efficient and well matched for light industrial motion duties, supported by 7.5 A continuous output current and 200 to 240 VAC mains voltage. A 32 kHz maximum output frequency stands out for smooth motor control and clean drive response.
To contact sales for pricing and lead time:
Payment Methods
Shipping Methods
Our Credentials
Product Description:
The FC-301P1K5T2134G0681 is an AC variable frequency drive manufactured by Danfoss and assigned to the VLT FC 301 Automation Drives series. Installed in control cabinets, it converts three-phase 200–240 VAC input power into a variable output that matches motor torque demands. This controlled output improves motor speed regulation and energy use in conveyors, pumps, and fan assemblies while allowing the connected equipment to operate at the speed required by the process.
The power section supplies 1.5 kW, or about 2.0 HP, of continuous mechanical output while delivering a steady 7.5 A to the motor terminals. Conversion efficiency reaches 0.96, resulting in 82 W of heat loss at full load. The inverter synthesizes carrier pulses at frequencies up to 32 kHz, allowing fine current shaping for quieter motor operation. When supplied by a 230 V system, the drive draws 2.99 kVA of apparent power, and the line conductors must handle a maximum current of 6.8 A during acceleration. A 12-bit analog output transmits process values to external controls. Two digital outputs report operating status to PLCs and other control equipment.
The transistor control outputs can each source up to 40 mA. Motor leads may use shielded cables up to 50 m long or unshielded cables up to 75 m long without exceeding the drive’s rise-time limits. Power terminals accept conductors with a cross-sectional area of 4 mm², matching the frame’s clamp blocks and supporting secure power connections. The short-circuit withstand rating is 100 kA RMS, allowing the drive to operate on industrial distribution systems with high available fault current when suitable protective devices are installed. Power exchange is balanced across the three input phases to limit uneven loading on the supply. The supported cable lengths and terminal capacity provide practical options for routing motor wiring within industrial machinery and control cabinets.
