FC-301P1K1T2131B1110 Danfoss
Wake Industrial LLC is not an authorized distributor of this product.
No Tariffs On US Orders- Straightforward Pricing: No Rush Fees, No Credit Card Fees
The Danfoss FC-301P1K1T2131B1110 is part of the VLT FC 301 Automation Drives series and supports a power rating of 1.1 kW with a maximum motor frequency of 590 Hz. It operates on three phase power with an efficiency of 0.96 and can deliver a continuous output current of 6.6 A. The drive offers 1 analog output with 12-bit resolution and 2 digital outputs with a current rating of 40 mA.
To contact sales for pricing and lead time:
Payment Methods
Shipping Methods
Our Credentials
Product Description:
The FC-301P1K1T2131B1110 is a compact AC variable frequency drive from Danfoss and belongs to the VLT FC 301 Automation Drives series. The unit converts fixed-frequency three-phase mains into a modulated voltage that lets controllers regulate induction-motor speed and torque in automated conveyors, pumps, and similar equipment. By aligning with the wider VLT AutomationDrive FC product group, it integrates into standardized control cabinets and provides the primary interface between PLC logic and the driven motor in industrial automation lines.
The drive accepts a nominal supply of 200-240 V AC and delivers up to 1.1 kW of continuous electrical power to the motor terminals. Under rated conditions the inverter can source 6.6 A of output current while drawing 5.9 A from the mains, and it reaches an energy conversion efficiency of 0.96, limiting waste heat to the specified 63 W power loss. Mechanical work capability is referenced at 1.5 HP. One analog output with 12-bit resolution supplies proportional feedback for process monitoring, and two digital outputs provide state or fault signals with a per-channel capacity of 40 mA. The control electronics update carrier pulses at a maximum switching frequency of 32 kHz, allowing fine control of motor flux and audible noise.
During acceleration the inverter can supply 7.3 A for short periods without derating. Open-loop flux mode supports output frequencies up to 300 Hz, while sensorless vector routines can command the motor toward the electrical ceiling of 590 Hz. Shielded motor-lead length may reach 50 m, or 75 m when unshielded, facilitating remote mounting of the controller. The three-phase power configuration and built-in thermal management allow installation in panels with limited ventilation where predictable heat dissipation is required for continuous duty.
