HQ908A6

Product Description:

The HQ908A6 from Danaher falls under the Timers and Controllers product family and stands out with a tough build made for demanding industrial spots. This timer is made for panel mounting, using the Cycl-Flex setup, so it fits flush into equipment racks or control boxes without sticking out. The unit works on 120 VAC power at a 60 Hz line frequency—a usual combo that doesn’t need tricky wiring or custom supplies in most factory spaces. Its current rating of 10 A gives it a good amount of switching strength, letting it handle heavier loads without adding an extra relay in the line.

A key part of this timer is the 15-minute time range—settings fall anywhere up to a quarter hour, which fits most conveyor, batch, or cycle tasks without overcomplication. Safety matters too, and this Danaher unit ships with certifications from UL US, CSA, and RU. Operating standards stay covered, and not every timer out there checks all three boxes. On the controller side, the SPDT contact configuration lets a person set it up for basic or alternate switching, using only what’s needed for the application. The faceplate, tightened down with Cycl-Flex hardware, keeps things vibration-resistant so contacts stay reliable when nearby machinery shakes.

Check operating temps, too: from -10 °F up to +140 °F with no tweaks required. Industrial control setups get weird on temps, hot or cold, and avoiding fails here pays off. Full length of 146.05 mm (5.750 in) makes it fit inside most common enclosures—clear without crowding out other components. Every HQ908A6 gets the CSA, RU, UL US tag for standards met. This part comes ready for lines where reliability tops the list. A utility timer ready to work long stretches and still keep cycle counts tight.