HP62S327A6

Product Description:

The HP62S327A6 is a timer from Danaher, built for situations where short, reliable timing is important in automation setups. This model lives in the Timers and Controllers lineup and has a surface mount build using a dial knob for easy settings. The part sits steady wherever it gets fastened, with fine dial adjustments helping operators hit whatever interval the job needs. The adjustable time range is wide, from 0.6 seconds up to 60 seconds, allowing a spread from quick shots to slow changes depending on requirements.

Operations get power at 120V 50/60 Hz, which fits into standard factory systems without needing special lines or conversions. Each reset goes quick, running at 1 ms reset time, so system cycles don’t get delayed after each use. Actual time repeatability rides right around ±0.25%, keeping sequences tight and less likely to drift off target over hours of runtime. For accuracy with the set dial value, the value gives ±3% of full scale, so settings hold close even with a lot of starts and stops. The timer case uses Lexan; this is a tough material that resists bumps or chemicals some factory layouts throw at it.

Connections get handled with a 9-terminal block ready to accept 16 AWG wire, making wiring less hassle for techs working in cramped cabinets. Output covers both ac and dc ratings, reaching up to 10A 1/3HP 120/240VAC resistive or 1/6HP 28VDC, 2.5A resistive so the timer drives relays or signals without sweating. Power draw hits 1.5 Watts, which isn’t much—a plus in tighter energy setups. The part handles cold and hot swings, with work range running from -23°C to 60°C, and keeps out shocks or grounding issues.