HP59A60192 Danaher
Wake Industrial LLC is not an authorized distributor of this product.
No Tariffs On US Orders- Straightforward Pricing: No Rush Fees, No Credit Card Fees
Current response time:
4 Minutes
50 Seconds
The Danaher HP59A60192 is part of the Timers and Controllers series and has a supply voltage of 120 VAC with a 60 Hz frequency. It features a reverse start clutch action, a maximum time setting of 10 hours, and is housed in an HN383 explosion proof cabinet. The output rating is 10 amps at 120 VAC, and the unit weighs 2 pounds 14 ounces.
To contact sales for pricing and lead time:
Payment Methods
Shipping Methods
Our Credentials
Product Description:
The HP59A60192 is an electromechanical timer built by Danaher within the Timers and Controllers series. This reverse-start interval device initiates or terminates machine sequences after a preset delay, providing coordinated on-and-off cycles for pumps, agitators, and safety interlocks in industrial automation. A spring-driven clutch couples with an internal synchronous motor so that each dial setting produces consistent mechanical motion at the output contacts. The electromechanical design provides timed control without requiring a separate electronic timing module, making the device suitable for industrial systems that use conventional relay logic.
The timer operates from a 120 VAC supply at 60 Hz. The motor has a burden of 2.45 VA, while the clutch draws 10.5 VA when energized. The armature pulls in within 28 ms, and a manual or remote command can reset the mechanism in 0.5 seconds to shorten the interval between operating cycles. The double-pole contacts are rated for 10 A at 120 VAC, allowing direct switching of compatible heaters or solenoids without auxiliary relays. Reverse-start action allows the timing wheel to begin running toward zero as soon as power is applied. This operating method supports delay-on-de-energize arrangements in which the contacts must remain in their timed state after the initiating condition changes.
Timing resolution is established by a dial engraved in 10-minute divisions, with a minimum setting of 20 minutes. The scale extends to 10 hours, and the mechanism has a repeatability of ±3 minutes throughout its service life. Silver-cadmium contacts provide an electrical service life of 250,000 operations, supporting extended operating intervals between contact maintenance. The timer has 15 screw terminals that separate the power, reset, and load circuits on the device. It is housed in an HN383 explosion-proof cabinet and weighs 2 pounds 14 ounces. The cabinet permits installation in Class I hazardous areas without requiring an additional enclosure, provided the device is installed in accordance with the applicable system and location requirements.
