Product Description:

The HN368 from Danaher comes from the Timers and Controllers product series, built to manage two timers side-by-side in control panels or machine stations. The cabinet goes with a dual unit design, offering separate homes for each timer so setup and visuals stay organized. The outer case uses steel construction and an approximate weight of 2 lb. 14 oz., giving stability while not adding a lot of bulk. The cabinet deals with power for both timers by relying on a DPST toggle switch that lets operators switch power on or off for the installed units.

Everything inside is sized for a HP5 CYCL-FLEX series timer or similar model, and installation fits two CYCL-FLEX case timers total, which is handy for processes or equipment needing backup or paired timing. Connections use a 9-position terminal block mounted right inside the box for easy wiring, and mounting is handled with 4 x 8-32 tapped holes. The setup expects service on 120/240 V AC at 60 Hz, which covers most plant or commercial voltage arrangements. For putting the cabinet where it belongs, surface mounting is standard, and there’s plenty of room with panel openings shaped for the particular timer cases.

Looking at endurance and usability, the steel enclosure resists bumps and daily knocks in automation sites, and placing it in high-motion or dusty locations works fine thanks to the tight build. Dimensions come to 5.750 inches in height, with a mounting cutout diameter of 3.187 inches so it slips into the right spot without fuss. Using the dual design cuts wiring clutter, and power switching in one place means fewer runarounds during service. The blend of terminal block access, protected housing, and quick-latch switches gives this cabinet a spot in any control system needing reliable, clearly organized timer coordination.