Product Description:

The 608600-0002 encoder cable belongs to the Dynapar Encoder Cables series manufactured by Danaher. It transfers position data from rotary or linear encoders to motion controllers within automated machinery, helping maintain reliable feedback for speed, direction, and count functions. Molded contacts on the sensor side and prepared conductors on the controller side support straightforward installation in conveyor lines, gantry systems, packaging equipment, and other motion-control applications.

With a length of 2 meters, the cable supports moderate distances between the sensor and control cabinet without leaving excessive service loops near moving axes. It is supplied as a preterminated cable assembly with an installed jacket, strain relief, and connector shell. Each conductor is 24 AWG, providing flexibility for routing through compact spaces while supporting the electrical requirements of encoder signal channels. The cable contains four leads for carrying the required feedback signals between the encoder and controller. The cabinet end has flying leads, allowing the conductors to connect directly to screw terminals, barrier strips, spring terminals, or compatible input boards without an additional plug.

On the encoder side, a circular M12 interface provides mechanical compatibility with industry-standard connector housings. The plug is a male M12 D-coded connector, which uses keyed alignment to prevent connection to an incompatible receptacle. Its 4-pin contact insert assigns one conductor to each contact and makes individual connections easier to verify during setup. The molded connector body provides strain relief where the cable enters the plug, helping protect the conductors from bending at the termination point. The open controller end gives the assembly flexibility for use with several terminal styles while the terminated encoder end connects directly to a compatible Dynapar device.