1400664-0025 Danaher
Wake Industrial LLC is not an authorized distributor of this product.
No Tariffs On US Orders- Straightforward Pricing: No Rush Fees, No Credit Card Fees
The Danaher 1400664-0025 is a 25 foot cable assembly from the Dynapar Encoder Cables series. It features a 6 pin MS connector (female) on the encoder side, flying leads on the non-encoder end, and supports Series 21 and 22 encoders. The cable uses 22AWG and 24AWG wire gauge and provides a differential signal through a 6 pin line driver output interface.
To contact sales for pricing and lead time:
Payment Methods
Shipping Methods
Our Credentials
Product Description:
The 1400664-0025 cable assembly is manufactured by Danaher for the Dynapar Encoder Cables series. It is an interconnect designed for incremental encoders, carrying power and differential quadrature signals from the sensing head to a drive or PLC input card. The fully terminated harness eliminates on-site crimping and provides consistent electrical connections for conveyors, pick-and-place axes, and other motion systems. Mechanical strain relief at each end protects the internal conductors from vibration commonly found in automated equipment.
The assembly is supplied in a length of 25 ft, allowing the encoder to be mounted on a moving carriage or remote shaft while the controller remains inside a cabinet. A molded hood houses a 6-pin industrial circular interface. This MS connector mates directly with the encoder bulkhead and locks in place with a threaded coupling. At the opposite end, stripped and tinned flying leads provide flexible connections to terminal blocks, solder lugs, or field-installable connectors. The power conductors use stranded 22 AWG copper to minimize voltage drop over the cable run. The signal pairs share an overall shield that limits electromagnetic interference from nearby motors and switching equipment.
The assembly supports a 6-pin line-driver output for transmitting encoder channels and their associated connections. The cable uses a differential transmission scheme, which improves noise immunity in industrial environments and supports receivers with 26LS31- or AM26LS32-style inputs. Its pinout matches Dynapar encoders in Series 21 and 22. This compatibility allows the cable to connect the supported encoders without modifying the standard pin arrangement. Two smaller drain wires made from 24 AWG strands are dedicated to shield termination. These drain wires provide a low-impedance path for coupled high-frequency interference without increasing the overall cable diameter.
