1400664-0005 Danaher
Wake Industrial LLC is not an authorized distributor of this product.
The Danaher 1400664-0005 is a shielded encoder cable from the Dynapar Encoder Cables series. It features a 6 pin line driver with MS connector (female) and has a length of 5 feet. The cable uses 22 AWG and 24 AWG wire gauge and provides differential signal type with flying lead termination.
Internal Product Review
The 1400664-0005 is a Dynapar encoder cable designed for encoder feedback applications, with a 6-pin line driver and differential signaling. Shielded construction and an MS female encoder connector support clean signal transmission and dependable integration. Flying-lead termination makes the cable a strong choice for precise and efficient field installation.
To contact sales for pricing and lead time:
Payment Methods
Shipping Methods
Our Credentials
Product Description:
The 1400664-0005 is a preassembled encoder cable manufactured by Danaher for the Dynapar Encoder Cables series. It provides a dedicated link between a Dynapar rotary encoder and drive or PLC input cards used in industrial automation, allowing motion controllers to receive accurate quadrature or absolute position feedback. By maintaining signal integrity over its rated length, the assembly supports precise servo loops that regulate velocity, position, and acceleration. Its standardized wiring arrangement reduces installation time and provides compatibility with common line-driver output stages.
The cable is wired for six-pin line-driver encoders, so its conductors provide the EIA-422 polarity required for high-speed differential signaling. A factory-fitted female MS connector mates directly with standard Dynapar devices, eliminating the need for field soldering on the sensor side. Continuous foil coverage and a drain conductor provide a shielded construction that limits electromagnetic interference from inverters and contactors. Signal integrity is further maintained through differential transmission along the entire run. The overall length of 5 ft suits panel installations where encoder junction boxes are positioned close to the motor. Stranded copper conductors in 22 AWG and 24 AWG sizes balance flexibility with low resistance, helping logic-level waveforms reach the controller with minimal attenuation.
The cable contains six leads, matching the pair-per-channel arrangement used for A, B, and index signals. The mating bulkhead or interface board accepts a six-pin connection, allowing direct point-to-point routing without intermediate adapters. The controller end terminates in flying leads, allowing the stripped and tinned conductors to connect to screw terminals, barrier strips, or solder lugs. This termination style accommodates different controller input arrangements while preserving the fixed connector at the encoder end. The combination of differential conductors and shielding helps protect low-voltage feedback signals in cabinets containing motor power cables, switching devices, and variable-frequency drives.
