1400635-0015 Danaher
Wake Industrial LLC is not an authorized distributor of this product.
No Tariffs On US Orders- Straightforward Pricing: No Rush Fees, No Credit Card Fees
The Danaher 1400635-0015 is part of the Dynapar Encoder Cables series and uses an opal colored cable with a wire gauge of 22 AWG and 24 AWG. It features a 10-pin MS female connector on the encoder side, 8 leads, and flying leads on the non-encoder termination. The output type for this cable is differential.
To contact sales for pricing and lead time:
Payment Methods
Shipping Methods
Our Credentials
Product Description:
The 1400635-0015 is an encoder feedback cable produced by Danaher within the Dynapar Encoder Cables series. It serves as the physical interface between a rotary encoder and a drive or PLC, carrying incremental position signals through a strain-relieved connection at the transducer end. The cable matches the mechanical connector used on many industrial tachometers, simplifying installation in motion-control cabinets and on motor housings without requiring additional junctions. Its durable construction is suitable for the vibration commonly encountered on conveyor lines, motor assemblies, and servo axes.
An opal outer jacket allows quick visual identification during panel service and contrasts with standard black control wiring. At the encoder end, a 10-pin female MS connector provides keyed engagement and positive locking with compatible miniature military-style receptacles, helping prevent signal interruptions while machinery is moving. Internally, the cable contains eight individually insulated conductors that support the A, B, and Z incremental channels, complementary signals, and power connections without unnecessary pairs. The copper strands are sized at 22 AWG / 24 AWG, balancing flexibility with current capacity so the shield drain and logic supply use appropriate conductor sizes. The conductors are arranged as twisted differential pairs to reduce crosstalk and maintain balanced waveforms over extended cable runs in electrically noisy industrial settings.
The controller side of the assembly terminates in flying leads, allowing the insulation to be cut back to the required length before the conductors are connected to terminal blocks, screw clamps, or IDC headers. This termination method supports direct routing inside a control cabinet and does not require a dedicated mating connector at the controller end. The balanced signal arrangement rejects common-mode electrical noise, helping preserve encoder feedback over longer distances before active repeaters become necessary. Uniform strain relief and consistent jacket coloring also support orderly cable routing across installations with multiple motion axes.