1400431-0005 Danaher
Wake Industrial LLC is not an authorized distributor of this product.
The Danaher 1400431-0005 is an encoder cable from the Dynapar Encoder Cables series with a 7-pin MS female connector on the encoder side and flying leads for the output termination. This cable is 5 feet in length, uses 22 AWG wire, and has an operating temperature range from -20 to 80 degrees Celsius.
Internal Product Review
The 1400431-0005 is a Danaher Dynapar encoder cable configured with a 7-pin female MS connector for secure encoder-side connection. Its 22 AWG conductors and flying-lead output termination support clean wiring and efficient integration in control assemblies. A wire temperature range of -20 C to 80 C makes this cable a dependable choice for consistent encoder service.
To contact sales for pricing and lead time:
Payment Methods
Shipping Methods
Our Credentials
Product Description:
The 1400431-0005 cable is produced by Danaher within the Dynapar Encoder Cables series. Intended for motion-control and feedback loops, this product links shaft encoders to drives or PLC input cards, transmitting incremental or absolute position data without signal loss over short machine distances. By integrating a prewired connector on the sensor side and open conductors for panel termination, the assembly streamlines installation and ensures that encoder signals are delivered with minimal electrical noise in industrial automation environments on modern servo axes.
Classified as an encoder cable, the assembly employs conductor shielding and impedance suited for differential A-, B-, and Z-channel signals from optical or magnetic sensors. Its overall length of 5 ft keeps propagation delay low while still providing slack for routing within protective drag chains. Each conductor is sized at 22 AWG, a cross section that balances voltage drop with flexibility so the cable can bend around tight machine corners. At the encoder interface, a female MS connector mates directly with standard military-style circular receptacles found on many Dynapar transducers, eliminating field soldering at the sensor. On the control-cabinet end, the jacket is stripped to expose flying leads, allowing individual conductors to be connected to terminal blocks or solder cups without proprietary plugs.
The connector follows a 7-pin arrangement, so all incremental quadrature channels, power connections, and shield continuity occupy dedicated contacts for reliable isolation. Internally, only 6 leads are populated; the spare position provides an option for a future index or temperature channel without requiring a different cable. The maximum conductor temperature is 80 °C, allowing placement near motors or transformers that radiate moderate heat. A minimum temperature of -20 °C supports cold starts in unheated warehouses or outdoor equipment.
