1400334-0015 Danaher
Wake Industrial LLC is not an authorized distributor of this product.
The Danaher 1400334-0015 is a cable assembly in the Dynapar Encoder Cables series, measuring 15 feet in length and made with 22 AWG wire rated for up to 75 degrees Celsius. It features a female MS connector on the encoder side with three leads and three pins, and has flying leads on the non-encoder end.
Internal Product Review
The 1400334-0015 is a Dynapar encoder cable assembly with an MS female encoder-side connector. The 3-pin, 3-lead configuration supports straightforward encoder integration with clean terminations. 22 AWG conductors rated to +75 C make this cable a dependable choice for standard industrial service.
To contact sales for pricing and lead time:
Payment Methods
Shipping Methods
Our Credentials
Product Description:
The 1400334-0015 cable is supplied by Danaher within the Dynapar Encoder Cables series. It is a dedicated interconnect that links incremental or absolute encoders to drive controllers and carries position signals in industrial automation systems. By bundling the conductors in a single assembly, the product simplifies routing between rotating sensors and stationary control cabinets. The consolidated cable also helps preserve signal integrity in motion-control loops by keeping the required connections together along the entire route.
This model is provided as a cable assembly, so the conductors, jacket, and terminations arrive prefabricated and ready for installation. A keyed female MS connector is fitted on the encoder end, providing a secure, vibration-resistant connection to compatible Dynapar feedback devices. The cable length of 15 ft supports short- to midrange layouts without creating excessive slack. Each conductor consists of stranded copper sized at 22 AWG, balancing flexibility with current-carrying capacity. Inside the jacket, the cable contains 3 leads, which are suitable for encoder arrangements that use supply, ground, and signal connections. This modest conductor set streamlines routing and helps minimize the cable bundle diameter in crowded equipment areas.
The opposite end terminates in flying leads, allowing each conductor to be crimped, soldered, or connected directly to terminal blocks and drive connectors as the installation requires. Signal allocation follows a 3-pin map that corresponds to the internal lead count and helps prevent wiring errors during field termination. The insulation system supports continuous operation at temperatures up to +75 °C. This temperature limit allows the cable to maintain dielectric strength near motors or power supplies that increase the temperature inside an enclosure. The assembly is mechanically and electrically compatible with the broader Dynapar Encoder Cables series and is intended for moderate-temperature encoder connections in industrial motion systems.
