Product Description:

The 111752-0002 is an encoder cable manufactured by Danaher and offered within the Dynapar Encoder Cables series. It provides a pre-terminated connection between rotary feedback devices and motion controllers in automated machinery. The cable carries incremental or absolute position signals while reducing on-site wiring and the risk of pinout errors associated with field-assembled connectors. Its prepared ends also provide a consistent connection for applications that require dependable feedback transmission between an encoder and a control cabinet.

This model is supplied as a complete assembly, with conductors that are cut, jacketed, and terminated at the factory to maintain consistent impedance along the cable length. A 17-pin connector on the encoder side organizes power, differential channels, and auxiliary lines into a single mating point. The connector uses a double-row housing with 2 × 2 mm contact spacing, allowing the contacts to fit within a compact interface while retaining keyed orientation. A shielded braid and foil combination diverts electromagnetic interference to ground and helps preserve the timing of incremental signal edges. Each conductor consists of tinned copper in 26 AWG, providing sufficient capacity for the low current requirements of optical or magnetic encoder electronics while remaining flexible enough for dynamic cable tracks.

The cable mates directly with F-series encoders, including the F14 and F18 models. The opposite end has flying leads for custom connections to a drive or terminal block. These leads can accommodate screw, spring, or push-in clamping interfaces already installed in a control cabinet. Twisted pairs support differential signal transmission, while the drain wire provides a direct grounding path for interference diverted from the signal conductors. The compact conductor bundle helps simplify routing through crowded enclosures and moving cable carriers without placing unnecessary strain on the encoder connection.