110158-0025 Danaher
Wake Industrial LLC is not an authorized distributor of this product.
The Danaher 110158-0025 is a cable from the Dynapar Encoder Cables series featuring a side-mount MS Bayonet female connector on the encoder side with 19 pins and 18 leads. It has a wire gauge of 24 AWG, a parallel interface type, and the non-encoder end consists of flying leads. The cable supports temperatures from minus 20 to 80 degrees Celsius and includes a mating connector.
Internal Product Review
The 110158-0025 is a Dynapar encoder cable featuring a 19-pin MS bayonet female encoder-side connector. Parallel interface support and push-pull output make signal transmission well suited for dependable encoder feedback circuits. An included mating connector adds installation efficiency, making the cable a practical choice for encoder integration.
To contact sales for pricing and lead time:
Payment Methods
Shipping Methods
Our Credentials
Product Description:
The 110158-0025 is a pre-terminated signal cable manufactured by Danaher within the Dynapar Encoder Cables series. It provides the physical link between a rotating encoder and downstream control electronics in automated machinery, carrying position data, power, and reference lines in one assembly. The cable provides an organized connection for encoder feedback circuits while reducing the amount of wiring required inside the machine. Its pre-terminated design also prevents individual conductors from placing excessive strain on the encoder connection.
The connector contains 19 contacts arranged to match the full channel set of Dynapar parallel encoders, and the shell uses an MS bayonet female connector that locks with a quarter-turn for vibration resistance. Inside the jacket, the conductors support a parallel interface, so each bit travels on its own line with minimal propagation delay. A total of 18 insulated leads are provided, while the remaining contact is grounded to the shell for shielding continuity. Stranded tinned copper conductors built to 24 AWG reduce loop resistance while keeping the bundle flexible for machine motion. The connector has a side-mount orientation, which limits the required bend radius at the encoder face. This arrangement allows the assembly to exit parallel to the mounting surface, reducing interference with nearby couplings or guards.
The cable is rated for continuous service at temperatures up to 80 °C and remains pliable at temperatures as low as -20 °C, covering typical cabinet and factory-floor conditions without supplemental heating. At the controller end, the cable is terminated with flying leads, allowing each conductor to connect directly to terminal blocks or solder pads. Output drivers in the associated encoder use a push-pull topology, and the conductors are paired and twisted to support bidirectional current flow while limiting crosstalk. A mating plug is included with the cable set, so a separate field connector is not required during installation. The jacket protects the internal conductors while maintaining the flexibility needed for routing through confined machinery spaces.
