108615-0015 Danaher
Wake Industrial LLC is not an authorized distributor of this product.
The 108615-0015 is a cable assembly manufactured by Danaher and is part of the Dynapar Encoder Cables series. This cable features an M23 female connector for the encoder side, supports compatible encoders H58 and HS35, and has a total of 10 leads with a 12-pin configuration. It uses 22 AWG and 24 AWG wire gauges and terminates with flying leads on the non-encoder end.
Internal Product Review
The 108615-0015 is a Dynapar encoder cable assembly designed for H58 and HS35 encoders. The M23 female encoder-side connector with 12 pins supports dependable signal termination in encoder applications. CCW connector orientation and flying-lead termination make this cable a practical choice for flexible industrial wiring.
To contact sales for pricing and lead time:
Payment Methods
Shipping Methods
Our Credentials
Product Description:
The 108615-0015 is a terminated cable assembly produced by Danaher within the Dynapar Encoder Cables series. It is designed to link shaft encoders to drives or PLC input modules, carrying incremental or absolute position signals together with auxiliary power. By supplying a matched connector at the encoder end and prestripped conductors at the controller end, the cable simplifies installation in industrial automation systems. This arrangement helps maintain signal integrity between rotating feedback devices and stationary control cabinets.
The cable form is classified as an assembly, and the 108615-0015 arrives factory-terminated. The encoder side uses a keyed M23 female connector, so the shield, differential pairs, and power pins are arranged according to the standard twelve-position insert. The insert has a counterclockwise orientation, allowing the plug to mate with housings that use a corresponding locating notch. The connector accommodates 12 conductors for complementary A, B, and Z channels, an index signal, and auxiliary power connections without requiring parallel cores. Inside the jacket, twisted pairs and drain wires use 22 AWG and 24 AWG copper strands. The larger wire gauge supports the supply current, while the finer pairs carry high-speed encoder signals with controlled impedance and minimal voltage drop.
The assembly interfaces directly with H58 hollow-shaft encoders and HS35 hollow-shaft encoders, allowing the connector and pin arrangement to align without on-site rewiring. The cable has a lead count of 10, leaving two leads available when the standard quadrature outputs use the remaining connections. These available leads can support thermal sensors or manufacturer-specific functions when required by the connected equipment. The cable supports any output driver style, including differential line-driver and open-collector arrangements, because its conductor layout helps control crosstalk. On the control-cabinet side, color-coded flying leads accept screw terminals or solder lugs. The flying-lead design also allows excess cable length to be removed after the cable run has been routed through the machine or cabinet.
