108595-0010 Danaher
Wake Industrial LLC is not an authorized distributor of this product.
No Tariffs On US Orders- Straightforward Pricing: No Rush Fees, No Credit Card Fees
The Danaher 108595-0010 is a cable assembly from the Dynapar Encoder Cables series with a female MS encoder connector and 7 pins. It is compatible with H20, H58, HS35, and HA725 encoders and has flying leads on the non-encoder end. The cable has 6 leads, supports single ended signals, and uses 22 and 24 AWG wire gauges with an operating temperature range from -20 to 105 degrees Celsius.
To contact sales for pricing and lead time:
Payment Methods
Shipping Methods
Our Credentials
Product Description:
The 108595-0010 cable from Danaher belongs to the Dynapar Encoder Cables series. It is supplied as a preterminated harness that carries incremental or absolute position signals between a shaft encoder and a motion controller in automated machinery. By combining shielded conductors with molded terminations, this product simplifies installation in conveyors, packaging equipment, and other axis systems that rely on clean feedback data for speed or position regulation.
This cable is built with 22 AWG and 24 AWG conductors so that power, index, and channel lines have suitable copper cross sections without adding excess bulk. At the encoder end, an MS connector with 7 pins is fitted; the shell is keyed and strain-relieved to maintain signal integrity in vibrating environments. The connector has a female insert that matches the threaded plug normally integrated into the encoder housing. Internal wiring fans out to 6 leads that terminate at the opposite end as flying conductors, providing flexibility when connecting the signals to terminal strips, solder lugs, or field connectors. The product is a standard cable assembly, and a mating plug is included with the set.
The wiring pattern supports H20, H58, HS35, and HA725 incremental devices from Dynapar, aligning each channel with the drive input requirements for single-ended signaling. The cable operates at temperatures from -20 °C to 105 °C, accommodating freezer installations and high-temperature motor compartments. The drain wire and twisted-pair layout help keep propagation delay consistent along the 1:1 pinout, while the keyed shell can be disconnected for maintenance without rewiring the control cabinet. Tinned conductors simplify soldering, and nylon insulation on both conductor gauges resists cuts and oil exposure during routing through drag chains or conduit.
