108594-0020 Danaher
Wake Industrial LLC is not an authorized distributor of this product.
The Danaher 108594-0020 is a cable assembly from the Dynapar Encoder Cables series, designed for use with H20 and HS35 encoders. This shielded assembly features a 6-pin MS female connector on the encoder side, 5 leads with stripped and tinned ends, and 22 AWG and 24 AWG wire gauge. It supports single ended outputs, including current sink and open collector.
Internal Product Review
The 108594-0020 is a Danaher Dynapar encoder cable assembly designed for H20 and HS35 encoders. A female MS connector and shielded construction support clean installation and dependable signal handling in encoder feedback applications. Support for current sink and open collector outputs makes the assembly a practical choice for consistent encoder interfacing.
To contact sales for pricing and lead time:
Payment Methods
Shipping Methods
Our Credentials
Product Description:
The 108594-0020 is a cable assembly manufactured by Danaher for the Dynapar Encoder Cables series. In automated machinery, it links rotary feedback devices to drive or PLC input cards, carrying incremental channels and supply lines while minimizing electrical noise. By providing a ready-made harness between H20-style encoders and control cabinets, it simplifies installation and maintains signal integrity throughout the cable run.
This model uses a shielded construction so the braid diverts electromagnetic interference away from the signal conductors. At the encoder end, it is fitted with an MS connector with female contacts, which uses the threaded coupling commonly found on industrial rotary encoders. Inside the outer jacket are five insulated conductors that carry power, ground, and the single-ended A, B, and Z output signals. The mating shell contains six contact positions; one position is reserved for the cable shield and helps maintain the reference potential. The assembly uses 22 AWG and 24 AWG conductors, with the heavier pair carrying supply current and the lighter trio transmitting logic-level pulses. It supports single-ended signaling, allowing direct connection to high-impedance counter inputs without differential receivers.
The non-encoder side terminates in flying leads, allowing each conductor to be routed to terminal blocks or solder lugs without additional adapters. The assembly is compatible with H20 encoders and HS35 incremental encoders, matching their connection requirements and strain-relief threads. Output devices that use open-collector drivers can be connected directly to compatible control inputs. Current-sink interfaces are also supported when used with suitable sourcing input modules. Each conductor has stripped and tinned ends, eliminating the need to remove insulation or tin the exposed wire before termination. The prepared ends promote consistent solder wetting and simplify attachment to terminal points, while the shielded cable layout helps protect encoder pulses from interference along the routed connection.
