108241-0065 Danaher
Wake Industrial LLC is not an authorized distributor of this product.
The Danaher 108241-0065 is part of the Dynapar Encoder Cables series and features a non-armored, shielded design with 6 leads and stripped and tinned finishes. It includes a 6-pin female MS connector for encoders with marker and single-ended output, with wire gauges of 22AWG and 24AWG.
Internal Product Review
The 108241-0065 is a Dynapar encoder cable configured for single-ended output with a 6-pin female MS connector. Shielded construction and a stripped-and-tinned lead finish support clean installation and stable signal performance. Support for a 22 with marker encoder and an index channel makes this cable a strong choice for precise feedback applications.
To contact sales for pricing and lead time:
Payment Methods
Shipping Methods
Our Credentials
Product Description:
The 108241-0065 is an instrumentation cable supplied by Danaher within the Dynapar Encoder Cables series. It provides a dedicated interface between a shaft encoder and a motion controller, carrying incremental position signals, reference pulses, and supply power in factory automation cells. A preterminated connector on the encoder side and prepared leads on the controller side eliminate ad hoc wiring, simplify installation, and preserve the signal fidelity needed for closed-loop speed or position control.
The cable uses a non-armored jacket, which keeps it flexible when routed inside guarded machine enclosures where crushing forces are low. Six conductors match the six-pin layout of the mating MS shell on the encoder side. The female MS connector locks with a threaded coupling to resist loosening under vibration. A copper braid and foil layer provide a shielded construction that attenuates electrical noise before it reaches the incremental signal channels. Each conductor terminates in stripped and tinned ends for attachment to drive electronics. The power and signal paths use 22 AWG and 24 AWG copper conductors, which limit voltage drop while maintaining a small overall bend radius.
The assembly is compatible with Dynapar 22 encoders with a marker, which provide incremental feedback and a reference pulse. Its wiring uses a single-ended signaling convention, allowing a straightforward connection to standard PLC high-speed counters without differential receivers. An index-channel conductor gives the controller a precise zero-position reference during each revolution. On the cabinet side, the cable terminates in flying leads that can be cut to the required length, fitted with ferrules, or connected directly to screw terminals. This termination arrangement accommodates different control cabinet layouts while retaining the six conductors needed for encoder feedback, marker transmission, and supply power. The threaded encoder connector supports a secure machine-side connection, while the prepared cabinet-side conductors allow routing through terminal assemblies without an additional connector interface.
