107865-0050 Danaher
Wake Industrial LLC is not an authorized distributor of this product.
No Tariffs On US Orders- Straightforward Pricing: No Rush Fees, No Credit Card Fees
The Danaher 107865-0050 is a cable designed for use with the AI25 Absolute Encoder as part of the Dynapar Encoder Cables series. It features a 17-pin end-mount MS connector on the encoder side, 17 leads with flying leads on the non-encoder end, and uses 24 AWG wire. The output type is parallel push-pull.
To contact sales for pricing and lead time:
Payment Methods
Shipping Methods
Our Credentials
Product Description:
The 107865-0050 is an encoder interconnect cable supplied by Danaher for the Dynapar Encoder Cables series. It is intended to route position data from a shaft encoder to control hardware in industrial automation systems. As a dedicated accessory rather than a general-purpose lead set, the cable links a Dynapar rotary encoder to I/O cards or motion controllers so that incremental or absolute position updates reach the PLC without signal loss.
The cable uses a 17-pin layout, allowing each absolute-output channel and its common returns to occupy dedicated conductors. Those conductors terminate on the encoder side in a female MS connector that threads onto the mating shell and seals the interface against contamination. Power and data share the same bundle and travel through 24 AWG copper conductors, which balance current-carrying capacity with the flexibility needed for dynamic runs on moving axes. The encoder presents its parallel data stream to downstream electronics through a parallel push-pull output, so each line actively drives both high and low logic levels to reduce susceptibility to induced electrical noise. Dedicated internal wiring also avoids signal multiplexing and makes individual circuits easier to trace during system diagnostics.
System compatibility centers on the AI25 Absolute Encoder, with pin assignments and shielding geometry aligned with that device’s electrical connections. An end-mount connector orientation simplifies mechanical strain relief by allowing the plug to sit flush against the encoder housing while reducing the required bend at the cable exit. At the controller end, the insulation is stripped to form flying leads, allowing each conductor to terminate directly on terminal blocks or compatible headers without an adapter. The cable follows Dynapar wiring conventions for insulation colors and drain-wire placement, helping maintain consistent conductor identification throughout the feedback circuit. Its connector arrangement supports a secure encoder-side connection while leaving the controller-side termination adaptable to the layout of the control enclosure.
