VT-UK2-3X/VT13615A/U233 Bosch Rexroth Indramat
Wake Industrial LLC is not an authorized distributor of this product.
MPN: R900559876
No Tariffs On US Orders- Straightforward Pricing: No Rush Fees, No Credit Card Fees
Current response time:
4 Minutes
29 Seconds
The Bosch Rexroth Indramat VT-UK2-3X/VT13615A/U233 is part of the VT-UK2 Universal Cards series and conforms to the Eurocard format with dimensions of 100 by 160 mm. This card features six operational amplifiers, five potentiometers, operates at an input voltage of 10 V, and outputs up to 5 mA at 10 V. It uses a DIN 41612 blade connector and adheres to the DIN 41494 card standard.
To contact sales for pricing and lead time:
Payment Methods
Shipping Methods
Our Credentials
Product Description:
The VT-UK2-3X/VT13615A/U233 is a plug-in signal conditioning board built by Bosch Rexroth Indramat for the VT-UK2 Universal Cards series. Within an automation rack, it provides adjustable analog processing so sensors and actuators can be matched to the operating range of the central controller. The card houses trimming elements, buffers, and simple arithmetic stages on a plug-in module, reducing cabinet wiring and simplifying service. It conditions low-level command or feedback signals before they reach the main control electronics, which helps align signal levels in mixed analog systems. This arrangement supports applications where gain and offset must be adjusted directly at the card.
The physical format follows the Eurocard convention, and its printed-circuit outline measures 100 x 160 mm, giving predictable clearances when stacked in a card cage. Fabrication complies with DIN 41494, while the rear edge carries a DIN 41612 backplane connector that mates with standardized female housings. Signal and power paths are routed through a Blade Connector profile, which supports repeated insertion cycles and maintains low contact resistance. This layout fits standardized racks used in industrial control cabinets and keeps edge alignment consistent from slot to slot. The backplane connection also allows the module to share common power rails and analog reference lines with neighboring control cards.
The electrical section is powered from a regulated 10 V supply that also serves as the internal reference for the analog stages. Each channel is buffered by 6 operational amplifiers arranged for summing, inverting, or non-inverting duties depending on jumper settings. Output loading is limited to 5 mA, which keeps the amplifiers within their linear range while driving short backplane traces, and the conditioned signal can swing up to 10 V at the card edge to match typical drive-controller inputs. Calibration is handled with 5 potentiometers, allowing gain and offset to be adjusted directly on the card. These circuits support analog signal conditioning without requiring a separate external processing module.
