Product Description:

The VPP40.3BIK-2G0NN-C3D-DN-NN-FW is an operator interface terminal produced by Bosch Rexroth Indramat within the VPP IndraLogic Terminals series. It integrates an industrial PC, a sealed keypad, and field connection ports so operators can monitor processes, acknowledge alarms, and adjust parameters without opening the control cabinet. By combining display, data entry, and network links in one housing, the terminal simplifies human-machine interaction on packaging lines, machining centers, and assembly systems. Its panel-based format also helps place control and status information close to the machine area where they are needed.

Processing tasks are handled by a Celeron P4500 1.86 GHz processor, which runs control logic while leaving headroom for visualization software. The unit also includes 2 GB of DDR3 memory, a 320 GB hard disk drive for recipe and log storage, and one PCI slot for an optional fieldbus or motion card. The TFT panel measures 38.1 cm (15") diagonally and renders graphics at 1024 × 768 pixels, giving a familiar layout for SCADA screens and machine menus. Data exchange with higher-level networks is supported by 2 × Ethernet TCP/IP ports, and removable media or service tools connect through 6 × USB 2.0 sockets. Foil keys on the front sheet provide tactile input that resists dust intrusion, while 15 g shock resistance helps protect internal components during machine vibration.

The power section draws 160 W from a regulated 24 V DC supply, allowing the terminal to share the same low-voltage bus as sensors and PLC I/O. A die-cast bezel with IP65 front protection blocks water jets and airborne particles, while the rear panel remains at IP20 so convection cooling can occur inside the cabinet. Total installed mass is 6.4 kg, which helps keep door loads low on swing-arm mounts and panel assemblies. The sealed front surface supports use in machine environments where routine operator input is needed without exposing internal electronics to the surrounding workspace.