Product Description

The TDA 1.3-050-3-D00 main spindle controller features three motor connection terminals with 5Nm tightening torque and M6 thread size. The Bosch Rexroth product must be installed inside a closed housing or a control cabinet that has a thickness of at least 6mm for the rear wall when it is made of aluminum. The power, NC, and feedback connections of the device are configured using the same terminal assignments or plug-in connector. The electrical connections of the unit are determined by its selected function options. It should be earthed separately to the supply module using an earthing cable with a minimum 10mm² conductor cross-section.

The controller features a Class F air humidity in accordance with DIN 40 040 specifications. The main spindle drives of the product are controlled by means of a microprocessor. The operating characteristics of these drives are determined by the plugged-in programming module. The keypad of the device is used to enter and edit its parameter values. The unit features a sticker on its side that provides the details needed in case of a replacement. This main spindle controller must take load factors into consideration when it operates outside the ambient temperature range. Wake Industrial can ship this TDA 1.3-050-3-D00 controller with a one-year warranty safely to your address.

The rating plate of this spindle controller is visible even when it is inside a control cabinet. This product incorporates a 16-bit parallel digital speed command interface. This command interface helps to connect the device to PLCs. There is no support for any additional interface or encoder input. It features anX11 connector for the Bb-ready contact at the bottom. The X1 connector is used for connecting the control voltage bus. The electrical connection accessories comprise two plug-in terminals for the Ready contact and motor thermistor connection, a connecting cable for the control voltage bus, and mounting rails to support the DC link circuit bus.