Product Description:

The SE-LB3.095.060-10.037 is a synchronous servo motor produced by Bosch Rexroth Indramat for the SE Synchronous Servo Motors series. Its mechanical form follows the IM B5 construction type, and the mounting face centers through a 95 mm register for accurate concentric alignment. Category N balance quality minimizes residual vibration when the rotor accelerates toward its operating speed. The shaft is supplied without a keyway, so clamping couplers can transmit torque without backlash. These features allow the motor to function as a compact drive element in automated pick-and-place or indexing stations.

At a nominal speed of 6000 rpm, the motor produces up to 26.0 Nm of torque, providing suitable power for fast positioning sequences. At standstill, the windings can carry 15 A, allowing static holding force without overheating during dwell periods. The circular flange measures 116 mm across and matches standardized gearbox patterns. The output shaft has a diameter of 19 mm and pairs with clamping hubs intended for medium-frame servo motors. A shaft length of 40 mm provides sufficient engagement depth for a secure mechanical connection. The 2.5 mm² motor cable cross-sectional area provides adequate conductor capacity for repeated peak cycles without excessive voltage drop.

A ramp-up time of 60 ms supports a quick response after each start command. The housing withstands mechanical impacts up to 6 g, helping protect the magnets and windings on machines that experience abrupt end-stop loads. Acoustic emissions remain at 58 dB(A), allowing installation near occupied work areas without additional acoustic shielding. For legacy velocity loops, the built-in tachogenerator supplies 1.8 V/1000 rpm. This proportional feedback allows a compatible drive amplifier to monitor motor speed and adjust its velocity control signal. The tachogenerator output changes with rotational speed, providing the controller with a direct analog reference during operation.