Product Description:

Bosch Rexroth Indramat manufactures the SE-LB3.095.060-00.000, a synchronous servo motor in the SE Synchronous Servo Motors series. The model converts drive current into tightly regulated rotary motion for pick-and-place stations, tool feeds, and general-purpose positioning axes in automated machinery. Its design follows construction type IM B5, so the frame is flange-mounted without feet and mates directly to gearboxes or machine plates to minimize stack length in compact installations.

The motor reaches a nominal speed of 6000 rpm, allowing fast indexing or spindle duties where high surface velocity is critical. A peak output of 26.0 Nm is available for short bursts, while a continuous static torque of 11.6 Nm supports holding loads at standstill without overheating. The motor ramps from zero to rated speed in 60 ms, reducing idle time between cycles. Mechanical resilience is supported by its 6 g shock tolerance, which helps protect alignment during handling and operation. The housing length is limited to 351 mm, and the electrical terminations accept 2.5 mm² conductors through a keyed circular connector. These features make the motor suitable for high-speed motion where rapid response and compact installation are important.

Mounting precision comes from a centering diameter of 105 mm and a flange size of 116 mm, providing a tight fit against locating shoulders on the machine side. Power is transmitted through a 19 mm shaft that is 40 mm long and machined with a keyway, and an A6×6×32 feather key is supplied for positive coupling to pulleys or rigid hubs. Total mass is 14.9 kg, which supports stable horizontal installation and helps reduce vibration during dynamic motion. The keyway shaft arrangement supports repeatable torque transfer under reversing loads.