SE-LB3.075.060-14.000
Wake Industrial LLC is not an authorized distributor of this product.
No Tariffs On US Orders- Straightforward Pricing: No Rush Fees, No Credit Card Fees
The SE-LB3.075.060-14.000 linear actuator is constructed from steel and measures 075x060 mm. Manufactured by Bosch Rexroth Indramat, this component is part of the SE Servo Motor Series with a pressure rating of up to 300 bar. It features a flange connection type and a corrosion-resistant finish.
To contact sales for pricing and lead time:
Payment Methods
Shipping Methods
Our Credentials
Product Description:
The SE-LB3.075.060-14.000 is a permanent magnet industrial servo motor built for mechanical engineering applications. The motor is a product of the reputable Bosch Rexroth Indramat company; in combination with the compatible T(A) or TC motor series, this industrial motor can comply with the most stringent dynamic industrial energy requirements. The magnets in the SE-LB3.075.060-14.000 servo motor are rare-earth magnets; these special magnets are responsible for the high power density, high efficiency and impressive torque density during operation. There is a brushless tacho generator and commutation sensor integrated into the housing of this servo motor; these motor components are important for speed monitoring and rotor position detection in the motor in real time. The bearings installed in this industrial motor have a service life that is greater than 20,000 hours, while the windings have a service life greater than 70,000 hours.
The SE-LB3.075.060-14.000 industrial servo motor is the long version of the motor series. During operation, the nominal speed of the product is about 6000 revolutions per minute. The output shaft present in this motor design is without a feather key or keyway; however, it features a holding brake that retains the load connected to the shaft when the motor is at a standstill.
There are two electrical connectors integrated into the housing of this industrial motor design: the power connector and the motor feedback connector. These electrical connectors also meet the IP65 protection classification of the motor. Each unit of the SE-LB3.075.060-14.000 servo motor design is equipped with a rating plate which features important information for the easy identification of the motor upon delivery. The current required by the motor at a standstill is 14 amperes, while the peak output current is about 84 amperes.
Frequently Asked Questions about SE-LB3.075.060-14.000:
Q: Is there an air blower attached to the SE-LB3.075.060-14.000?
A: No. The heat produced by this motor is regulated through an efficient process of natural convection and thermal radiation.
Q: What are they types of sockets present on the SE-LB3.075.060-14.000?
A: The SE-LB3.075.060-14.000 has two types of sockets. One is for the power and break connection, and the other is for the motor feedback connection.
Q: Is the SE-LB3.075.060-14.000 equipped with an holding brake?
A: Yes. There is an holding brake integrated into the motor. The brake retain the load at the motor shaft when it is at standstill.
Q: What is the permitted ambient temperature for the operation of the SE-LB3.075.060-14.000?
A: The SE-LB3.075.060-14.000 is built to be used at an ambient temperature that is between 0 to 40 degrees.
Q: Does the SE-LB3.075.060-14.000 cause a lot of noise?
A: The Maximum noise pressure level of the SE-LB3.075.060-14.000 is 58 decibels when measured at a distance of 1 meter from the motor.
