SE-B3.095.060-10.000 Bosch Rexroth Indramat
Wake Industrial LLC is not an authorized distributor of this product.
No Tariffs On US Orders- Straightforward Pricing: No Rush Fees, No Credit Card Fees
The Bosch Rexroth Indramat SE-B3.095.060-10.000 is a synchronous servo motor from the SE Synchronous Servo Motors series. It has a nominal speed of 6000 rpm and provides a maximum torque of 26.0 Nm, with a mass of 14.5 kg and rotor inertia of 2.07 x10^-3 kgm2. The motor draws a peak current of 92 A and has a torque constant of 0.64 Nm per ampere.
To contact sales for pricing and lead time:
Payment Methods
Shipping Methods
Our Credentials
Product Description:
The SE-B3.095.060-10.000 servo motor is produced by Bosch Rexroth Indramat and belongs to the SE Synchronous Servo Motors series. It is a permanent-magnet AC unit designed to supply controlled rotary motion for positioning axes, pick-and-place heads, and rapid feed drives in industrial automation. By combining a high rated speed with a compact mechanical envelope, the motor serves applications that demand fast indexing without enlarging machine footprints. This type of motor is well suited to repetitive motion sequences where quick starts, stops, and reversals are part of normal machine operation.
The motor reaches a nominal speed of 6000 rpm, allowing direct coupling to high-throughput mechanisms without intermediate gearing. At standstill, it can hold a load with a static torque of 9.5 Nm, while continuous energization draws a standstill current of 15 A. Dynamic torque development is tied to the back EMF; the voltage constant is 64 V/1000 rpm, so the controller must raise phase voltage proportionally as speed increases. Acceleration behavior benefits from a rotor inertia of 2.07 × 10⁻³ kg·m², which is low enough for short cycle moves while still helping smooth small load fluctuations. Internally, the three-phase stator has a winding inductance of 8.4 mH and a resistance of 0.66 Ω, which influence current rise and copper losses during duty cycles. These electrical characteristics support responsive motion when the motor is matched with an appropriate servo drive.
For short bursts, the motor delivers a maximum torque of 26.0 Nm, supported by peak phase currents up to 92 A. The assembly weighs 14.5 kg, and its body length remains within the 320 mm limit, simplifying installation inside compact machine frames. An electrical time constant of 12.7 ms matches high-bandwidth current loops, enabling prompt torque corrections when loads vary. Torque production scales linearly with the 0.64 Nm/A constant, giving predictable response to controller commands. The shaft is supplied without a keyway, and a plain Ø19 × 40 mm journal accommodates clamp or shrink-disc couplings while reducing stress concentrations in high-speed service.
