RL2-022CBB Bosch Rexroth Indramat
Wake Industrial LLC is not an authorized distributor of this product.
MPN:
The Bosch Rexroth Indramat RL2-022CBB is part of the RL2 Motor Power Cables series and features a basic cable design with a cross section of 1.0 mm². This power cable is compatible with IndraDrive drives and MS2x motors with Plug U, supporting up to 5,000,000 bending cycles. It uses a direct connection and includes an M23 power connector for 2nd generation motors.
Internal Product Review
The RL2-022CBB is a Bosch Rexroth Indramat RL2 Motor Power Cable designed for use with IndraDrive systems and MS2x motors featuring Plug U. Its M23 power connector and direct connection design provide secure and efficient power delivery. With a dynamic bending radius of 7.5xD and a durability rating of 5,000,000 bending cycles, this cable is well-suited for demanding motion applications.
To contact sales for pricing and lead time:
Payment Methods
Shipping Methods
Our Credentials
Product Description:
The RL2-022CBB cable is produced by Bosch Rexroth Indramat within the RL2 Motor Power Cables series. It is intended to deliver three-phase supply current from a Rexroth drive controller to a servo motor in automated machinery. Supplied as a finished assembly with straight plugs and shielding, the cable simplifies power routing between the control cabinet and a moving axis. Its low-impedance conductors support the consistent electrical performance required for precise motion control. The shielding also helps limit electromagnetic interference when the cable is routed near other power and signal lines inside industrial equipment.
The cable is rated for 5,000,000 bending cycles, allowing repeated travel in an energy chain while remaining within its intended service life. During motion, conductor strain is minimized by observing a minimum dynamic bending radius of 7.5 × D. Static installations may use a tighter minimum bending radius of 5 × D without compromising the integrity of the insulation. Each power core has a cross-sectional area of 1.0 mm², providing adequate current capacity for compatible MS2 motor torque classes while keeping the cable flexible. An M23 power connector is molded onto the cable at the motor end. This mechanically keyed interface resists vibration and allows the cable to be connected without an intermediate motor-side terminal block.
The RL2 Basic cable uses four line conductors and four smaller signal conductors in a 4 × L + 4 × 0.75 mm² arrangement. This conductor layout allows brake and temperature signals to share the same jacket as the motor power conductors. A direct connection on the drive side eliminates intermediate terminal blocks and is suitable for IndraDrive inverters that monitor the connected motor through their power modules. On the load side, the wiring is compatible with MS2x motors equipped with plug U from the 2nd generation. The conductor twist and shielding configuration help control electromagnetic interference along the cable route. The finished assembly also reduces the amount of field wiring needed between the drive controller and motor, while its straight connector arrangement supports routing through common cabinet and machine layouts.
