RKL4533 Bosch Rexroth Indramat
Wake Industrial LLC is not an authorized distributor of this product.
MPN:
No Tariffs On US Orders- Straightforward Pricing: No Rush Fees, No Credit Card Fees
The Bosch Rexroth Indramat RKL4533 is a motor power cable from the RKL Motor Power Cables series with an outer diameter of 18.5 mm and a jacket made from PUR material. It features a 6.0 mm² power wire cross-section, 5 million bending cycles, and crimp pin plug connectors. The cable supports wire temperatures up to 90°C when fixed and 80°C when flexible.
To contact sales for pricing and lead time:
Payment Methods
Shipping Methods
Our Credentials
Product Description:
The RKL4533 cable is a motor power lead manufactured by Bosch Rexroth Indramat within the RKL Motor Power Cables series. It is intended to connect servo drives to Indramat motors in automated machinery where continuous motion and high current draw require a dedicated, preassembled cable. The cable carries the three-phase supply, protective earth, and auxiliary control cores in a single jacket, allowing cabinet builders to route one harness instead of separate power and sensor lines. The protective earth conductor is color-coded green and yellow for clear identification, and factory-crimped contacts at each end maintain consistent electrical resistance and mechanical retention in dynamic cable chains.
The motor phase conductors have a cross-sectional area of 6.0 mm², which limits voltage drop during acceleration currents. Two auxiliary pairs are integrated for holding-brake or temperature-sensor circuits. The first pair uses 1.0 mm² copper conductors to minimize bulk, while the second pair uses 1.5 mm² conductors for higher load capacity. The overall bundle follows the wiring pattern 4x6.0 + (2x1.0)StC + (2x1.5)StC, so the required power and auxiliary conductors reach the motor through one molded plug. At the drive end, the connector has 3 + PE power contacts. Seven additional crimp-pin terminations carry control signals and keep high-current connections segregated from low-level circuits.
The PUR sheathing sustains flexing over 5 million carrier movements without cracking, and its matte, adhesion-free surface slides easily along guide channels. During installation, the cable can be looped in energy chains down to a radius of 7.5 × D, preserving conductor geometry and signal integrity. The cable can operate at up to +90 °C in fixed installations, while moving sections remain flexible at temperatures up to +80 °C. Its nominal diameter of 18.5 mm provides enough internal spacing for the current-carrying conductors while still fitting standard 20 mm gland plates. The polyurethane jacket also protects the conductor bundle from abrasion caused by repeated travel through cable carriers. Proper bend-radius control reduces mechanical stress on the copper strands and molded connector terminations during continuous motion.
