RAC 2.3-150-460-A0I-W1 Bosch Rexroth Indramat
Wake Industrial LLC is not an authorized distributor of this product.
MPN: R911277264
No Tariffs On US Orders- Straightforward Pricing: No Rush Fees, No Credit Card Fees
The Bosch Rexroth Indramat RAC 2.3-150-460-A0I-W1 is an AC main spindle drive controller from the RAC Spindle Drive Controllers series. It features a rated current of 150 Amps and operates at a connection voltage of 3 x AC 400 V, 50 Hz, or 3 x AC 460 V. The device is cooled using an internal blower and has an incremental encoder output interface.
To contact sales for pricing and lead time:
Payment Methods
Shipping Methods
Our Credentials
Product Description:
The RAC 2.3-150-460-A0I-W1 belongs to the RAC Spindle Drive Controllers series produced by Bosch Rexroth Indramat. It is intended to regulate the torque and speed of high-performance spindle motors in machining centers and other automated tooling stations. It translates motion commands from the CNC or PLC into precise three-phase output for the connected motor.
This unit is designed for supply networks that deliver 3 × AC 400 V, 50 Hz, ±15% or 3 × AC 460 V. The power section is rated for a continuous 150 A output, allowing the drive to support large synchronous or induction spindles during prolonged rough-cut cycles. Thermal control is handled by a built-in fan, so cabinet airflow must accommodate the exhaust path but no external heat sink is required. Command signals are introduced through an analog velocity interface. The ±10 V differential reference permits high-resolution speed control and rejection of common-mode noise, and this interface is identified here as the analog (±10 V) speed command. Field wiring terminates on connector X4, 9 poles, which groups ready, fault, and enable lines with the low-level command channels in one detachable plug.
The unit provides an incremental encoder output, so downstream position loops or supervisory equipment can monitor actual shaft speed without a separate feedback converter. The controller is classified as an AC Main Spindle Drive Controller, which confirms that it is intended for high-speed tool drives rather than general-purpose axis control. The unit uses version 3 software and components, and it is part of series 2. There is no additional bleeder resistor, and the housing has no auxiliary encoder input, so regenerative braking energy must be absorbed by the motor load or external dissipators and only the primary feedback channel is supported.
Frequently Asked Questions about RAC 2.3-150-460-A0I-W1:
Q: What connection voltage does the RAC 2.3-150-460-A0I-W1 support?
A: The RAC 2.3-150-460-A0I-W1 operates with a rated connection voltage of 3 x AC 400 V at 50 Hz (with +/-15% tolerance) or 3 x AC 460 V.
Q: What is the rated current capability of the RAC 2.3-150-460-A0I-W1?
A: This spindle drive controller can deliver a rated current of 150 A.
Q: How is the RAC 2.3-150-460-A0I-W1 cooled during operation?
A: Cooling for this model is handled by an internal blower and built-in fan.
Q: What type of additional interface does the RAC 2.3-150-460-A0I-W1 feature?
A: The incremental encoder output is provided as an additional interface on this drive controller.
Q: What type of speed command input does the RAC 2.3-150-460-A0I-W1 use?
A: Speed commands are received via an analogue input of +/- 10 V.
