PST610E.101-L Bosch Rexroth Indramat
Wake Industrial LLC is not an authorized distributor of this product.
Wake Industrial LLC is not an authorized distributor of this product.
MPN: R911335600
Ask for AvailabilityThe Bosch Rexroth Indramat PST610E.101-L is a thyristor power unit from the PST Thyristor Power Units series. It features a nominal current of 130 Arms and a transformer power rating of 95 kVA, with air cooling and a protection rating of IP20. The device offers 16 discrete inputs and 12 discrete outputs, with a programming interface of V24 / RS232 and overvoltage protection provided by an MOV.
Internal Product Review
The PST610E.101-L is a Bosch Rexroth Indramat thyristor power unit with a 2-phase thyristor design and 130 Arms nominal current. Air-cooled construction and IP20 protection support dependable cabinet operation in controlled industrial environments. A 24 VDC logic supply and V24 / RS232 programming interface simplify integration, making the PST610E.101-L a strong choice for dependable power control.
Have a part to sell?
Wake Industrial Warranty
To contact sales for pricing and lead time:
Payment Methods
Shipping Methods
Our Credentials
Product Description:
The PST610E.101-L is a two-phase thyristor power unit built by Bosch Rexroth Indramat and assigned to the PST Thyristor Power Units series. In an automation cell, it modulates line voltage to resistive or inductive loads, allowing proportional power control that conventional contactors cannot achieve. The internal design combines phase-angle firing with feedback logic so that furnace zones, drying tunnels, or similar equipment receive consistent thermal energy under varying line conditions. That operating method helps maintain smoother process heating than simple on/off switching, especially when load response changes during startup or batch transitions.
The power stage carries a nominal current of 130 Arms and is supported by a transformer rated at 95 kVA, giving the unit enough headroom for high-energy heat sections. Continuous operation is limited to a 50% duty cycle to keep silicon junction temperatures within safe limits, and excess heat is removed by air cooling, which simplifies enclosure layout. For short test pulses or alarm horns, the output terminals can source up to 1 A of discrete current, coordinated by 16 digital inputs and 12 digital outputs on an opto-isolated backplane. The 2-phase thyristor topology uses screw lugs sized for 50 mm² conductors, allowing short, low-impedance links to the bus bars. This arrangement lets the unit coordinate firing control, status signaling, and interlocks within the same cabinet assembly.
Configuration data resides in buffered RAM sustained by a 3.6 V AA lithium battery, and parameters are edited through a V24/RS232 port that supports point-to-point links with a laptop or HMI. The serial connection allows direct access to operating values and stored settings without requiring a network gateway. Control electronics are powered from a dedicated 24 VDC supply, keeping gate triggers and diagnostic LEDs stable during line voltage dips. The housing carries an IP20 protection rating, so the unit must be mounted inside a control cabinet. MOV surge arrestors and full isolation between logic and load help protect the control section during industrial heating operation.
