NFD02.2-480-016

MPN: R911279996

No Tariffs On US Orders
  • Straightforward Pricing: No Rush Fees, No Credit Card Fees
    Available

Preparing your secure checkout page...

NFD Mains Filter Series Rexroth Indramat Bosch. The NFD02.2-480-016 has a Nominal Voltage of AC 115 to 480 V, and a rated current of 16 A

Quote Request Form:

Warranty
Wake Industrial Warranty
To contact sales for pricing and lead time:

Payment Methods

Visa
Mastercard
AmEx
Wire Transfer

Shipping Methods

DHL
UPS
FedEx
Freight

Our Credentials

Cary Chamber
DUNS Registered
SAM Registered
BBB Accredited

Product Description:

The NFD02.2-480-016 mains filter produced by Bosch Rexroth has an operating frequency between 0Hz and 50Hz at 45°C. The product has a nominal voltage ranging from 115VAC to 480VAC. The inductors present in the device permit low frequency or DC currents to pass through while simultaneously blocking unwanted harmful high-frequency currents. The unit lessens the amplitude of any frequency signal that is more than the filter cut-off frequency. It may get damaged if it is not earthed properly. The filter can function without any fault if it is used with shielded cables from the manufacturer. The device renders assurance of the compliance of EMC limits.

The filter is primarily used with the HCS product group of converters. The earthing connection of the product should always be as short as possible. The mating surface of the device should not have paint on it. The unit lowers the interference that appears in electronically controlled motors. It also dampens the interferences present in the cables connected from the mains. The mains filter can reduce both asymmetrical and symmetrical interferences that occur with three-phase units connected electronically. This product has 175mA to 190mA leakage current at 50Hz when one of the phases encounters a failure.

The device and the equipment that it protects must be in close proximity to each other. It is necessary to replace the unit if the transient voltage spikes are very high and may cause damage to the varistors. The product must be placed only in the upright position. The ground wire of the filter is to be connected with a conductor that has a cross-section of 10mm2. This connection is done by means of a ring cable plug or a plug connector. The product is equipped with IP 20 protection rating. This NFD02.2-480-016 mains filter has a warranty period of one year and is delivered in durable packaging.

Line
02
Nominal Voltage
AC 115 to 480 V
Rated Current
16 A
  • nfd02.2-480-016
  • NFD022480016
  • NFD02 2 480 016
  • NFD2.2-480-016

Motion Industries logo
3M logo
IBM logo
Gexpro Logo
Caterpillar logo
NASA logo
Ford logo
Vallen logo