Product Description

The Bosch Rexroth MSK050C-0600-NN-S1-UP0-NSNN is a servo motor with maximum speed of 6000 RPM. The ‘servo’ type indicates that the motor forms a feedback-based closed-loop system. The integrated singleturn motor encoder sends feedback to the drive controller that controls the motor speed and other parameters. The optical encoder on the MSK050C-0600-NN-S1-UP0-NSNN supports Hiperface and is rated for 128 signal periods. Other motor features include a shaft with keyway and seal, rotatable power and feedback connectors and standard and Ex design. The motor does not feature a holding brake. However, a 6 Nm electrically-releasing holding brake is available for MSK050C motors and can be ordered if required. The MSK050C-0600-NN-S1-UP0-NSNN cools via natural convection. Forced cooling can be used to improve the rate of cooling. The housing of the motor has an ingress protection rating of IP65.

Therefore, the housing provides complete protection from dust and from low-pressure jets of water. The motor can be installed near the operating machinery which helps to reduce installation and also makes troubleshooting easier. The length of the MSK050C-0600-NN-S1-UP0-NSNN is 203 millimeters. The diameter of the motor is 95 millimeters. The diameter of the motor shaft is 9 millimeters. The length of the motor shaft that protrudes outside the main housing is 40 millimeters. The centering diameter of the motor is 131 millimeters. The width of the motor flange is 98 millimeters. The diameter of the mounting holes on the flange is 9 millimeters. Weight of the MSK050C-0600-NN-S1-UP0-NSNN motor is approximately 5.4 kilograms. The recommended ambient conditions for motor operation include 0 to 1000 meters altitude and 0 to 40 degrees Celsius temperature. Only qualified personnel should install the MSK050C-0600-NN-S1-UP0-NSNN motor.