Product Description

The MSK050C-0450-NN-S2-UP0-RNNN synchronous servomotor from Bosch Rexroth can be used in potentially explosive areas. This motor may cause personnel injury or damage to property if it is not used as intended. The device belongs to the MSK product group of such offerings from the manufacturer. The unit should always be used in its original state without any hardware modifications. It operates in conjunction with a drive controller. The controller helps in controlling and monitoring the operation of the motor. This motor can operate at a maximum temperature of 55°C with derated data. The product has a very hot housing surface during and soon after operation.

The device is not equipped with a holding brake. The unit supports an encoder with an EnDat 2.1 interface. It has a size code of 050. The servomotor has a B5 size frame as per EN60034-7 specifications. The product is balanced with the complete key. This device features a 240° rotatable connector for its electrical connection. The unit depicts increased concentricity quality. It must be ensured that the cables are not damaged when the motor is used. The product portrays derated performance when the specified operating limits are exceeded. This device features a climatic category of 3K3 during operation in accordance with DIN EN 60721-3-3 standards.

The motor supports a maximum allowed vibration load of 10m/s² between 10Hz and 2,000Hz frequency. The product features an IP 65 degree of protection in compliance with EN 60034-5 specifications. The device can be installed both horizontally and vertically. It should be ascertained that there is no fluid accumulation at the output shaft when the servomotor is installed vertically with the shaft facing upward. The motor shaft and bearings are subject to both radial and axial loads during operation. The MSK050C-0450-NN-S2-UP0-RNNN synchronous motor is available with a one-year warranty and can be shipped globally.