Product Description:

The MOT-FC-NV3-FCB-286T-4-6CL-30-C3L-WEG is an AC induction motor manufactured by Bosch Rexroth Indramat as part of the MOT Low Voltage Induction Motors series. In automated material-handling lines, the motor couples directly to gearboxes or pumps, converting electrical power from the plant mains into continuous rotational motion for actuators and conveyors. Its design integrates with contactor panels or variable-frequency drives that coordinate acceleration, steady-state speed, and safe shutdown sequences.

Its shaft can deliver 30 HP while drawing a full-load current of 35.1 A at 460 V, which helps determine conductor sizing and upstream protection requirements. At this operating point, the unit reaches a full-load efficiency of 93.6%, minimizing heat losses during continuous duty. The stator is wound for mains voltages of 230/460/380 V, permitting installation on North American or international power grids without alteration. The magnetic design provides a synchronous speed of 1800 rpm, which serves as the reference speed that drive controllers use to calculate slip and load torque.

The mechanical interface uses a C-face, foot-mounted pattern that corresponds to the F-1 arrangement and flange code C, enabling installation with standard NEMA 286T mounting provisions. A heavy cast-iron housing adds mass for damping and encloses a four-pole rotor that produces uniform torque from a balanced three-phase supply at 50/60 Hz. The enclosure has an IP55 rating, protecting the internal components against dust ingress and water jets encountered on washdown lines or outdoor conveyors. The terminal box is fixed on the left side to simplify conduit entry when the motor is mounted vertically or horizontally, and the motor can power automated pumps, fans, and gear reducers during extended operating periods.