Product Description:

The MOT-FC-NV3-FCB-284T-4-6CL-25-C3L-WEG is a three-phase induction motor manufactured by Bosch Rexroth Indramat for the MOT Low Voltage Induction Motors series. This NEMA MG-1-compliant unit converts electrical power into mechanical shaft rotation for conveyors, pumps, and general plant equipment that requires constant-speed operation. In an automation cell, it functions as the prime mover and can operate with a variable-frequency drive or an across-the-line starter. The motor provides dependable torque for machinery designed around continuous-duty operation.

The motor delivers 25 HP at the shaft, indicating the continuous mechanical output available to the connected load. Its stator windings accept 230/460 V or 380 V and operate on power networks running at 60/50 Hz, supporting both North American and IEC installations. At the applicable higher-voltage connection, the motor has a full-load current of 29.5 A, which assists with sizing branch-circuit protection and power cabling. Electrical efficiency reaches 93.6% under rated load, limiting conversion losses and reducing heat generation during prolonged operation. A four-pole rotor establishes the electromagnetic field pattern needed to produce stable torque with low vibration across the operating speed range. The dual-voltage winding arrangement also allows the motor to accommodate common industrial distribution systems.

The enclosure provides IP55 protection, guarding internal components against dust ingress and water jets commonly encountered in washdown areas. Four poles provide a synchronous speed of 1800 rpm on a 60 Hz power supply, matching gearboxes designed for standard base speeds. The stator uses an IC411 TEFC cooling arrangement, which moves air over the exterior frame while keeping the internal components enclosed. Its cast-iron housing fits a 284/6TC NEMA frame, allowing installation on bases with the corresponding mounting pattern. A C-face flange connects directly to compatible reducers, while the motor feet provide stable support when secured to a machine base. The terminal box is located on the left side, providing a convenient wiring path for installations that use top-entry conduits.