Product Description:

The MOT-FC-NV3-FCB-254T-4-6CL-15-C3L-WEG is an AC induction motor produced by Bosch Rexroth Indramat for the MOT Low Voltage Induction Motors series. Within automated plants, it converts three-phase electrical power into steady mechanical rotation for conveyors, pumps, and compressors that run at fixed speed throughout long production cycles. Its induction design supports continuous operation in industrial systems that require consistent shaft rotation under sustained mechanical loads.

Its base frame size of 254T establishes foot spacing, shaft height, and flange geometry compatible with standard NEMA accessories. The housing has an IP55 protection rating, so internal components are shielded from dust and low-pressure water jets on factory floors. Cooling follows the IC411 - TEFC pattern; an external fan drives air across the finned, totally enclosed casing to remove heat without pulling contaminants through the windings. Rated mechanical output reaches 15 HP, providing sufficient torque for mid-range pumping or conveying duties. When connected to a 60 Hz supply, the motor has a synchronous speed of 1800 rpm, providing a predictable relationship between line frequency and shaft velocity for equipment that does not require variable-speed operation.

The stator frame is made from cast iron, adding rigidity and vibration damping that help protect the bearings during continuous operation. The motor uses a foot-mounted arrangement; the integral feet bolt directly to the skid, while a C-flange permits close-coupled pump installation without realignment. Its four-pole configuration produces the magnetic field sequence needed for operation from a 60 Hz supply. The continuous S1 duty classification permits the motor to operate indefinitely at its rated load and allowable temperature rise. Power leads enter through a terminal box fixed on the left side, simplifying cable routing when starters or drives are installed on that side of the enclosure.