MOT-FC-ET2- V1-315S-4-5CB- 110-C3T-HOY Bosch Rexroth Indramat
Wake Industrial LLC is not an authorized distributor of this product.
No Tariffs On US Orders- Straightforward Pricing: No Rush Fees, No Credit Card Fees
The Bosch Rexroth Indramat MOT-FC-ET2- V1-315S-4-5CB- 110-C3T-HOY is part of the MOT Low Voltage Induction Motors series and has a rated power of 110 kW with a rated speed of 1480 min-1. This motor weighs 840 kilograms and delivers a maximum torque of 1550 Nm with a rated voltage of 400 V. It operates with a power factor of 0.88 and has a sound pressure level of 76 dB(A).
To contact sales for pricing and lead time:
Payment Methods
Shipping Methods
Our Credentials
Product Description:
Bosch Rexroth Indramat manufactures the MOT-FC-ET2-V1-315S-4-5CB-110-C3T-HOY as part of its MOT Low Voltage Induction Motors series. This three-phase motor uses a squirrel-cage rotor for dependable operation with a low-voltage power supply. It is intended for fixed-speed drives in automated material-handling lines, pump stations, and general process machinery where constant torque is required.
The motor delivers a rated shaft power of 110 kW when the stator is energized at a nominal line voltage of 400 V and draws a phase current of 192 A. On a 50 Hz power supply, the four-pole design provides a rated mechanical speed of 1480 rpm, allowing standard gear ratios to be used without overspeeding. Full-load efficiency reaches 0.94, indicating that approximately 6% of the electrical input is lost as heat. This level of efficiency helps limit energy consumption and the amount of heat that the motor must dissipate during continuous operation. A delta winding connection allows the rated current to be shared evenly across the stator phases. The motor’s low-slip operation also helps keep its temperature rise within the insulation limits during continuous-duty service.
The motor provides a peak shaft torque of 1550 Nm, supplying additional torque for process startups or intermittent overloads before protection trips at 480 A. Its cast-iron frame weighs 840 kg, providing thermal mass that helps absorb short periods of elevated current without rapid temperature increases. A power factor of 0.88 limits reactive demand on supply feeders and can reduce the electrical capacity required from upstream equipment. Acoustic emission is rated at 76 dB(A), which supports operation on an open plant floor where surrounding equipment and installation conditions are considered. The two pole pairs establish the motor’s operating speed on a 50 Hz supply. A rotor inertia of 2.87 kg·m² balances acceleration response with stable speed regulation, while the rated torque of 705 Nm supports the steady load after transient conditions have passed.
