Product Description:

The MLS200S-3A-0600-NNNN is a secondary track section produced by Bosch Rexroth Indramat for the MLS Synchronous Linear Motors series. As part of a moving-coil linear drive, the section carries the magnet array that interacts with primary coils to create thrust for gantries, pick-and-place axes, or machining tables. Because the magnetic rail is supplied as a finished section with sealed surfaces, it supports clean, high-duty linear stages and reduces the amount of custom fabrication needed around the active track. This arrangement is suited to industrial automation systems that require repeatable linear motion over modular rail lengths.

The component has an overall depth of 235 mm and a working face width of 600 mm, which helps it fit within the machine frame while providing a broad magnetic surface for the primary. The individual module length is identified as 0600, so adjacent rails can be tiled without field discontinuities when longer travel is required. Magnetic poles repeat every 37.5 mm, a pitch that affects force ripple behavior and the position update behavior expected from the servo system. The enclosure is rated IP65, allowing installation near coolant spray or airborne dust, and fastening holes are arranged along the outer edge so the unit seats flush to the machine bed while keeping screw heads outside the active magnetic field.

The secondary part weighs 16.1 kg, which is relevant when calculating bridge acceleration and support loading. A base plate made of steel supports the C45 chromatic magnet carrier, while a stainless steel V4A cover sheet provides surface protection and serves as the mechanical protection layer for this model. The magnetic array consists of permanent magnets, and the polarity follows the S-pole marking used for the Secondary Motor Type S arrangement. Fixing screws anchor the rail in place, and the motor size 200 code matches MLS primaries of the same frame width.