Product Description:

The MLP200D-0060-FT-N0CN-NNNN belongs to the MLP Synchronous Linear Motors series manufactured by Bosch Rexroth Indramat. As a liquid-cooled primary section, it delivers linear thrust along a magnetic track so that automation equipment can position loads without belts, screws, or gearboxes. The size 200 body and a pole width of 37.5 mm match the secondary track geometry used in high-speed pick-and-place modules, gantry routers, and precision milling tables.

During continuous duty, the mover supplies 5560 N of thrust, while momentary demands can reach a maximum force of 17750 N. When the coil is de-energized, permanent magnets generate an attractive force of 25400 N that must be considered when sizing bearings and safety stops. At the rated phase current of 25.2 A, the coil produces its continuous thrust, whereas short bursts up to 126.2 A are acceptable for acceleration. The winding code 0060 corresponds to an inductance of 13.7 mH and a resistance of 2.74 Ω, which influence drive tuning and thermal load. A voltage constant of 127.2 Vs/m describes the back EMF generated as the slide moves, and the regulator must accommodate this value at the motor's nominal speed.

Heat from copper losses of 4969 W is removed by liquid cooling that circulates 8.0 l/min of coolant through internal channels. The inlet may be pressurized to 10.0 bar, and flow across the exchanger creates a pressure loss of 2.4 bar. At full thrust, the mover reaches 60 m/min, while unloaded travel can attain 140 m/min for rapid positioning. A force constant of 220.40 N/A provides a linear relationship between current and thrust across the operating range. Thermo-encapsulation protects the windings against vibration and moisture, and all power leads are routed through the front of the housing. No encoder is installed, so external position feedback must be provided by the machine.