Product Description:

The MLP200D-0060-FT-N0CD-NNNN is a primary section in the MLP Synchronous Linear Motors series manufactured by Bosch Rexroth Indramat. By driving a moving carriage directly along its magnetic track, the unit eliminates ball screws or rack transmissions, making it suitable for production cells that demand high positioning speed and repeatable linear thrust in packaging, electronics assembly, or machining automation. This direct-drive arrangement reduces backlash and mechanical wear, which helps maintain smooth travel on axes that cycle rapidly and reverse direction frequently.

The motor delivers a continuous thrust of 5560 N, while its force constant of 220.4 N/A links output force directly to phase current for predictable control-loop tuning. A rated phase draw of 25.2 A is paired with a winding resistance of 2.74 Ohm, so conductor losses can be calculated for thermal management. The back-EMF constant is 127.2 Vs/m, indicating the voltage the drive must supply per meter per second of speed. Nominal velocity reaches 140 m/min, and at the full force rating the mover can still reach 60 m/min. The 37.5 mm pole width sets the magnetic pitch, and winding code 0060 matches these electrical values. Liquid cooling circulates through an internal channel with 0.45 l of coolant, kept below a 10 bar inlet limit, and the short 2.4 minute thermal time constant shows that winding temperature responds quickly to load changes.

A peak thrust capacity of 17750 N and an allowable surge current of 126.2 A support rapid index moves. An inherent attractive force of 25400 N keeps the primary section seated against the secondary rail, and the mover mass, including the thermo-encapsulation that protects the coil set, is 61.3 kg. The entire assembly carries an IP65 rating to block dust and low-pressure water jets. The motor ships without an encoder, leaving feedback selection to the machine builder, and the size 200 frame follows series conventions for mechanical footprint and mounting alignment.