Product Description:

The MLP200A-0060-FT-N0CN-NQNN primary section is a synchronous linear motor produced by Bosch Rexroth Indramat. It belongs to the MLP Synchronous Linear Motors series. By driving a magnet track directly, the unit delivers controlled linear motion without gearboxes, ball screws, or belts, a configuration often applied to gantry loaders, high-speed pick-and-place modules, and machine-tool axes where precise force control is required.

The motor can sustain a continuous thrust of 2415 N and tolerate peak loading up to 7450 N. A downward magnetic preload of 10700 N acts on the secondary rail, so the mechanical guidance must absorb this attractive force. Thermal losses reach 1700 W during rated operation, so the stator housing is equipped for liquid cooling. Coolant enters through front-routed hoses that share the passage with the power conductors, which use 6.0 mm² wires inside an 18.5 mm diameter cable supplied at 2 m length. The encapsulated winding uses a thermo-encapsulation method to protect the copper packs, and no encoder is installed, so position feedback is normally provided by an external scale. The primary mass is 28.3 kg and must be supported by the machine carriage.

The sealed housing carries an ingress rating of IP65, enabling the mover to operate in environments with sprayed coolant or airborne dust. When driven at maximum force, travel velocity is limited to 60 m/min, while higher speeds are possible at lower thrust according to the drive curve. Maintaining temperature stability requires a coolant flow of 2.44 l/min and an inlet pressure not exceeding 10 bar. The laminated secondary must remain below 70 °C to preserve magnetic properties. Motor length code A and size 200 identify the active coil dimensions, and the wire-through-front connection scheme simplifies routing inside compact slide assemblies.