Product Description:

The MLP152A-0060-FT-N0CN-NNNN is a synchronous linear motor primary section produced by Bosch Rexroth Indramat for the MLP Synchronous Linear Motors series. This component generates direct linear thrust along an aluminum track, eliminating ball screws or belts in pick-and-place systems, gantries, and machining centers. By housing the active windings in a sealed stainless steel body, the unit translates drive current into precise, controllable force that integrates with servo drives on the DC bus.

Electrical performance centers on the DC bus rating of 750 V, which sets the available electromagnetic power and matches compatible drive inverters used on common power rails. Heat extracted through liquid cooling keeps copper temperature stable during continuous duty; the design relies on an internal channel that carries conditioned water-glycol coolant so the active surface stays below its limits. Force is commutated across a 37.5 mm electrical pole pitch, a spacing that determines magnetic wavelength and converter position loop resolution. At peak load the mover can advance at 60 m/min, permitting high throughput on medium-stroke axes. The housing meets IP65 so dust and low-pressure water jets cannot reach the stator windings during operation.

Thermal safeguards supplement the liquid circuit. Coolant may rise only 10 K between inlet and outlet, and the mounting surface itself is limited to a 2 K increase, preserving alignment in precision frames. A passive sensor raises a warning at 145 °C and commands shutdown at 155 °C, protecting the 0060 winding pack. Power and feedback conductors are routed through the front of the coil, and the supplied cable set is 2 m long to reach junction boxes without splices. The coils are thermo-encapsulated, the encoder slot is left vacant for external feedback devices, and the A-length size 152 format fits standardized secondary plates.