Product Description:

The MLP102C-0060-FT-N0CN-NNNN is a synchronous linear motor primary section produced by Bosch Rexroth Indramat for the MLP Synchronous Linear Motors series. In an automation cell, it serves as the moving coil that develops thrust directly along a guideway, eliminating ball screws or belts. This direct conversion of drive current into linear force supports rapid positioning cycles and precise repeatability on pick-and-place, gantry, or cutting axes where backlash from rotary-to-linear mechanisms would be undesirable.

The stator coils are maintained by a closed coolant circuit that relies on liquid cooling; circulating fluid removes heat at the copper windings so continuous force is not limited by temperature rise during sustained motion. Power and feedback conductors exit the housing as wires routed through the front, which simplifies routing when the primary section is mounted deep inside a machine frame or carriage. Coil windings are sealed by a thermo-encapsulation method that bonds insulation and improves vibration tolerance. The electromagnetic stack uses the 0060 winding code, which sets its resistance and inductance so that the matching drive can deliver rated current without magnetic saturation. Mechanical proportions correspond to Size 102, giving an active width that pairs with standard secondary tracks of the same family.

The electrical interface presents a 7.9 nF capacitive load to the inverter, and this value of leakage capacitance is important for meeting EMC targets and for setting ground-fault monitors on the drive. Position feedback devices are not mounted because the unit ships with no encoder installed, so a separate external scale or resolver can be selected to match the required accuracy. As a linear motor, the coil generates bidirectional force instantly and allows high acceleration profiles while keeping mechanical wear low. The separate feedback arrangement also lets the control system use measuring devices that match the required travel length and resolution.